Special Offer - Save 10% on Orders Of Titan SPE Over £400
This range of tie allows masonry walls to be tied so as to provide restraint in one direction whilst allowing movement in the other direction. This is achieved by placing a debonding sleeve over the part of the tie which is to be embedded in the wall, allowing the tie to move within the sleeve. Also used in movement joints where they occur in long runs of brickwork, the slip ties spanning over a vertical joint preventing vertical movement but allowing horizontal expansion and contraction.
Sold in packs of 50Nr ties, inclusive of suitably sized debonding sleeves.
Design
Used over a movement joint in a run of brickwork or blockwork with safety embedment detail at one end and a debonding sleeve conenciton at the other. Please refer to the enclosed datasheet and product drawing.
Material
Manufactured from grade 304 stainless steel.
Behaviour in relation to fire
Non combustible (as defined in the national Building Regulations)
Durability
Excellent corrosion resistance and a service life of not less than 60 years.
Compliance
Tested in Shear to BS EN 846-7:2012. Shear Load Capacity 2060N.