The
use of bonding belts are: V-belt, pentagonal belt, PU round belt, PU
tube, plastic strips and other products can be easily melted.
The temperature of the equipment is usually between 180 degrees and 200 degrees.
How to use the adapter:
1,
fixed. The belt to be connected is fixed in the groove (usually V,
O-groove) below the aluminum fixture (the clamp main refers to the
gasket and nut). Specifically, remove the nuts on both sides of the nut
and nuts (depending on the diameter of the belt, if the belt can be
inserted directly into the groove, do not remove the nut and gasket),
the belt into the groove, the gasket and Nuts re-fixed in the groove
above the sides of the plywood in a parallel state, the spacing is about
2cm or so is appropriate (can be placed in the middle of the thermostat
heater)
Tips:
PU round with a small diameter of the polyurethane belt, please put the
round belt on the top of the tank there, so that the round belt 2
connector alignment, then the larger diameter of the round belt or red
polyurethane ribbons please put the bottom The inside of the groove! The
The
2,
heating. Will be heated to the constant temperature heater (the best
temperature of the belt connection at 160-180 degrees), the fixed belt
heating (the premise of the heat belt can not be bubbles, otherwise
affect the connection effect), and then docking, the fixture Manual
clamp nut tightened to the belt docking firm;
3, re-processing. Belt docking to complete, to be completely cooled after the removal of the belt scraping, leveling.