Water Temp. Sensor

This works with all Alfanos that use the metal screw connectors, as shown in photo.

Long lead that reaches from the Rotax engine to the Alfano head unit, on the steering wheel. This will fit all karts that use a 10mm fine or 1/8 NPT thread sizes, this includes most KF1, KF2, KF3, KGP, ICC and karts that the sensor screws into the tee piece in the radiator hose.

Spec;

• Length 150cm +/-5cm
• Tolerance +/1%
• Pressure Tested
• 1 year guarantee *

This is made in the UK by Kart-Crazy.co.uk - it is NOT made by Alfano.

*Guarantee covers the sensor ONLY. We recommend installation by a qualified person.

Installation Notes – The sensor has a tapered thread designed to fit in 10mm fine used as standard in karts. The thread is “self sealing” and will not screw all the way in.
Screw the sensor into its housing finger tight. Ensure the wire is not being twisted. Then tighten the sensor another 2 to 5 turns until it feels firm. Run the engine and check for a leak. If there is tighten another ½ turn.

A little PTFE tape can also help if needed.
DO NOT over tighten!