1:50 scale showman's 16 supercar 1950s-60s traditional dodgems kit

NOTE! this model does not come with printed instructions or yellow/red roof covering

you can download the instructions pdf and free printable roof covering pdf from www.lobokit.co.uk

There is also a build aid photo pdf with photos to help building

This is an MDF laser cut model kit of a traditional oval Fairground dodgems track

with 16 1950-60 supercar type dodgem cars 3d printed in high detail 

This kit is designed as a static model

It is based on dodgems around the 1950s to 1960s 

I have supplied an optional front sign board, many tracks did not have this but some did 

The kit is supplied on laser cut MDF boards, the parts easily detach using a knife to cut the remaining holding tabs

The kit has been designed to give the look of the original with all the intricate roof and fencing woodwork

The arena has etched panels and buffers

If you wish to put the wire mesh electric contact panels on the underside of the roof, 

there is room for this but you will need so supply and build your own as this is not supplied.  

Assembly instruction manual pdf now available to view or download at 

lobokit.co.uk 

The red/yellow roof covering is not supplied with this 

but I have produced a free pdf document that is printable on 8 x A4 sheets of paper 

you can print and cut these out if you wish and use them on the model, the download link for these is at 

lobokit.co.uk

The 16 cars are 3D printed using High resolution resin, they are very detailed and quite a good finish compared

to standard 3d printing

they are supplied with the separate steering wheels

These can be glued with superglue or epoxy etc

You would need to supply your own poles for the cars, these can be 1mm plastic rod or tube glued on

or very thin piano wire with insulation stripped from a piece of wire slid over it.

This is a great addition to any layout and is a fantastic model when painted and your own lighting added etc

This kit is quite easy to build, there are a few fiddly bits but nothing major

the Kit is assembled using wood glue or similar.

you will receive the MDF kit, a download link for roof tarp/ instructions etc, 16 x 3d printed cars with 16 separate steering wheels.

The overall size of the top is, 540mm wide x 296mm from front to back

From floor to peak of roof is 98mm

 The base is approx. 499mm wide x 255mm from front to back

The cars are 35mm long x 23mm wide x around 15mm high plus top of steering wheel