This is an OEM Husqvarna black oil cap used on the models listed below. This is the venting version used on earlier saws which did not have a separate oil tank vent. It screws into a 20.7mm (0.81") hole versus the 23.7mm (0.93") hole of the later saws with the non-venting caps. The four small vent holes are not plugged and the threads are not cracked. If I find the black rubber tank seal is badly cracked, it will be replaced with a new Nitrile rubber seal.

DO NOT OVER-TIGHTEN THE CAP, THE THREADS ON THESE OLD CAPS WILL CRACK - NO REFUND IF IT IS RETURNED WITH CRACKED THREADS.

Used on models 40, 44, 61 (early), 162, 240s, 240se, 240sg, 340se, 340sg, 444.

The pictures are of the actual item you will receive.

This part may not fit all years or be used in the same manner for the listed saws. Since I do not have your saw, you are responsible for determining if it is correct. If you are unsure what you need, please send a message and I will try to help. Please include a picture or the text of your saw's serial number tag so I can try to determine when it was manufactured.

I give combined shipping refunds when possible.

Visit my eBay store (Barrys Chainsaw Shop) to find many other Husqvarna chainsaw parts. If you do not find what you need, send a message and I will check my inventory.

v2