1 x Quality BMW Performance Bonnet Stripes Decals /Stickers
Made from top quality automotive grade vinyl
Size: 1200mm x 114mm trimming required for exact fit
PLEASE STATE BONNET STRIPE COLOUR & LOGO DESIGN COLOUR/S
& SEND ME A EBAY MESSAGE.
We recommend that you consult your local sign making fitting company, But any novice fitter is able to install these graphics. If unsure of your fitting capabilities we recommend that you watch youtube fitting guides.
Applying your vinyl Graphics ensure the surface is clean and free from dust or grease. Graphics are suitable for dry or wet application method. We cannot be held responsible for incorrectly or badly installed products. I.e trapped air bubbles, or ripping of the vinyl if you do not take your time when installing your product.
Application Instructions For Decals
Follow These 7 Easy Steps
1. Place design face up on a flat surface and with the plastic card rub over the graphic ensuring the entire graphic has adhered to the application tape.
2. Turn over the graphic face down and begin to peel away the backing paper slowly ensuring the graphic is stuck to the application tape. Carefully replace wax paper and refer to step 1 if the graphic is still stuck to the wax paper.
3. With the wax paper now removed ensure the application surface is clean and dry before continuing. A generic glass cleaning spray will do the job great, wipe clean and dry with a lint free cloth.
4. Carefully line up your graphic on to your chosen location ensuring no pressure is applied to the graphic itself until you are happy. For large graphics it is recommended that the chosen location is marked out before application.
5. Using the plastic card apply pressure to the graphic starting from the middle and work outwards smoothing out any creases or air bubbles as you go.
6. Starting at one corner gently pull away the application tape at 180 degrees to the graphic ensuring the graphic has stuck, if not replace application tape and rub over until it adheres.
7. Finally check your graphic for any air bubbles present, if there are use a pin or a needle and gently prick the bubble and apply light pressure to remove it.