- Genuine:
- SKU:19299230
- Other Names:Transmitter
- Description:
Corvette. This part requires programming and/or special setup procedures GM Service Information describes the procedures and special tools needed to ensure proper operation in the vehicle
4 buttons
Battery included with the remote - Condition:New
- Replaces:10253839, 10432147
- Sold In Quantity:1
VEHICLE FITMENT
| Year | Make | Model | Body & Trim | Engine & Transmission |
|---|---|---|---|---|
| 2000 | Chevrolet | Corvette | Base | 5.7L V8 - Gas |
| 1999 | Chevrolet | Corvette | Base | 5.7L V8 - Gas |
| 1998 | Chevrolet | Corvette | Base, Indianapolis 500 Pace Car | 5.7L V8 - Gas |
| 1997 | Chevrolet | Corvette | Base | 5.7L V8 - Gas |
PROGRAMMING PROCEDURE INSTRUCTIONS
Pre-Warning & Considerations
The RFA module will cancel the programming sequence if:
- The programming mode is excited through the DIC.
- The ignition is turned off.
- Three transmitters have been programmed to the car.
- The RFA system has been in program mode for more than 2 minutes and no key fobs/transmitters have been programmed.
A key fob/transmitter may not communicate and/or become out of sync if:
- The key fob/transmitter battery is disconnected.
- The Corvette battery is disconnected.
- The key fob/transmitter and Corvette are separated for more than 5 weeks.
- The RFA module is disconnected from the car.
Programming Procedure
- Turn the ignition switch to the RUN position.
- Turn the radio radio OFF.
- Press the RESET button on the Driver Information Center (DIC) to clear any Instrument Panel Cluster (IPC) warning messages.
- Press the OPTIONS button on DIC until the IPC display is blank.
- Press and hold the RESET button for THREE seconds.
- Next, press the OPTIONS button and hold it until the ‘FOB TRAINING’ message is displayed.
- At this point, the programming system is active. When ready to begin programming the key fob, press the RESET button.
- Once the RESET button has been pressed, the DIC will display the ‘HOLD LK + UNLK 1ST FOB’ message. On the un-programmed key fob, simultaneously (at the same time) press and hold the LOCK and UNLOCK buttons for 12 to 13 seconds. The IPC will indicate when the transmitter has been programmed to the car by displaying the ‘FOB LEARNED’ message. Repeat this step for each additional key fob/transmitter. (Up to three key fobs can be programmed.)
NOTE: If a programmed key fob/transmitter quits communicating, the codes may be out of sync. If you have an extra programmed key fob, bring it within range of the car and press the LOCK and UNLOCK buttons simultaneously for 6 seconds. The horn will beep once, signaling all the transmitters are in sync again.
The remote you are purchasing is an original OEM remote. Why pay dealership prices when you can buy this one at a fraction of dealer cost.
No emergency key insert or key included.
GUARANTEED PROGRAMMABLE!
FREE BATTERY INCLUDED!
MOST USED KEY FOBS SOLD ON EBAY ARE LOCKED AND NEED THE INTERNALS REPLACED IN ORDER TO BE PROGRAMMED AGAIN.
DONT TAKE THE RISK!
BETTER THAN DEALER PRICES!
ALL KEYS ARE IN THEIR ORIGINAL OEM SEALED PACKAGING.
ALL ITEMS SHIPPED IN A PADDED ENVELOPE VIA USPS FIRST CLASS.
CONFIRMATION WITHIN THE USA
BUYER IS RESPONSIBLE FOR TALKING WITH A LOCKSMITH TO VERIFY PROPER FIT TO VEHICLE BEFORE PURCHASING. PLEASE MATCH FCC ID AS WELL AS PART NUMBER TO YOUR EXISTING KEY FOB.
Pennsylvania residents add 6% sales tax.