BrandLongrun
ColorBlack
MaterialPlastic
StyleDiaphragm
Product Dimensions6.38"L x 3.35"W x 1.97"H
Power Sourcedc
Item Weight1.4 Pounds
Maximum Flow Rate3 Liters Per Minute
Voltage12 Volts (DC)

About this item

  • 【Safe & Durable】LONGRUN 12V Water Pump is equipped with a quick plug and an overvoltage protection device. If the maximum water flow exceeds 65 PSI, the electronic switch will automatically turn off. When the water inlet and outlet values return to normal, it will start working again!
  • 【Reduce Noise】Diaphragm Sprayer Pump base uses a soft rubber bracket, the diameter of the support hole is 0.2", which can effectively reduce the noise caused by vibration.
  • 【Improve work efficiency】The fresh water pump uses premium brushed pure copper coil motor, which improves the service life, reduces the resistance in the working process, and makes your work more efficient.
  • 【Widely Used Pump】The diaphragm pump is widely used in agricultural and life. Including garden sprinklers, lawns, showers, boat taps, caravans, campers, RV, boats, family gardens and camping.
  • 【Notice】All of LONGRUN water pump have been strictly tested before leaving the factory, including test voltage and water pressure. Therefore, little water to be found inside this sprayer pump is normal, which will not affect your use. Its to protect the diaphragm from damage due to long-time no use.

LONGRUN water pump is a portable device and can be applied in several household applications. These pumps are used for pumping the huge amount of water from one place to another. The main purpose of a water pump is versatile. A quality pump may be perfect for draining water from a low flooded region, refilling the bathtub, circulating pesticides otherwise fertilizers.

How to use LONGRUN diaphragm sprayer pump?

  1. Connect the water pump to the inlet and outlet pipes. You must ensure that the inlet/outlet pipe and the pump are tightly connected to prevent air from entering, otherwise, it will cause low pressure or water leakage.
  2. Install a filter at the water inlet.
  3. Connect the pump to the power supply. The power supply parameters must meet the input requirements of the motor.
  4. Turn on the power and the pump starts to run.