10mm 90Deg 3 Flute Countersink Counter Sink Chamfer Cutter Screw Head Drill Bit Rotary Router Power Tools

This handy fluted countersink cutter is used to provide an angled inlet at the entrance to a drilled hole. This may be required to allow the correct seating for a countersunk-head screw or to provide the lead in for a second machining operation such as tapping.

Detail

1 piece Countersink

Approximate Dimensions

(Also see picture gallery for dimensions)

Total Length: 50mm

Head Diameter: 10mm

Shank Diameter: 6mm

Material: High Speed Steel 4241

For use with carbon steel, sheet iron, insulation board, PVC board, wood etc

A few words to assist your buying experience

Welcome and thank you for visiting! My brief policies are below and are aimed at helping a clear and efficient buying process for you:

Postage

I will be happy to combine postage to help reduce costs for items purchased in my store. I will post all items from within Australia and following full payment I will typically post within 24 hours.

You may choose Standard, Registered or Express Post when completing checkout.

Payment

I accept PayPal and Bank Transfer for payment. Please let me know if you will be using bank transfer, so that I can look out for the funds.

To assist a speedy delivery, I would appreciate prompt payment. However, if you are expecting to delay your payment please let me know, as communication is helpful.

Delivery Issues

If you any have issues with your delivery, please do not provide neutral or negative feedback – please contact me directly. By communicating, we’ll find an agreeable solution to any problem.