Power: 150W. |
Input: DC12V. |
Output: AC 110V-200V-220V (as photo shows). also can 110v-0-110v. |
Quiescent Current: 0.05A around. |
Output waveform: frequency square wave. |
Output frequency: 20KHz around. |
Protection: no protection. |
PCB board using military grade plate, Size 5.8 * 5.8 cm, mainly used for: electronic DIY. |
Before the inverter stage. |
|
Note:
The board is a high frequency square wave AC output is generally inductive electrical. |
Tape can not "mortars, fen coil transformer etc. ‘. |
Take a small load (LED lights phone charger DVD set—top box, etc.) connected to the. |
Output voltage of the recommendations, such as a low gear: 172V or 200V. |
Load large work long hours (>=100W) is recommended to increase the heat sink. |
Power can not be reversed. The other power supply and Power cord should be large enough current. |
Do not overload Do not short circuit output. |
Frequency output load voltage multimeter measurements will show higher (is not correct,not actual voltage). |
|
The default output voltage wiring as follows: ‘for reference only:
V0--V2=110V V0--V3=175V. |
V0--V4=200V V0--V5=220V. |
V5--V4=20V V5--V3=45V. |
V5--V2=110V V4--V3=28V. |
V4--V2=90V V3--V2=62V. |
Dimensions: 43mm x 47mm. |
|