This is a perfect upgrade so you don't have to add a Pillar Pod or drill holes in your dash. It uses the stock vent surround and instead of the vent section you CA glue the tabs in place on the gauge housing.

From what I read these will fit both the CRX and Hatch as they share the same side vents.

Pictured with AEM X-Series Gauge (Not Included) but any 2 1/16th (52mm) gauge should fit with no issues.

This is a 3D printed part and will be printed in a Black Carbon Fibre infused material to help with strength and heat resistance.

The hole for the vent direction adjuster has been left open so air can still blow out with no issues for those chilly or when using AC days.

These are 3D printed so little flaws will be expected but will not effect product.