Brand New Coolant Heated spin on fuel filter with two 5/8" ports for hot coolant  that warms the fuel to 195 deg F.

All metal design with 2 mounting holes in the top of the casting.  

This unit comes with a 10 micron Fuel Filter and Water Separator (manufacturer will vary) with 14mm X 1.5 thread size.   Note this filter uses the same filter element as the Mercedes 220D, 240D, 300D, 300CD, 300SD, and 300TD.

This unit is very versatile with the inlet and outlet ports on both sides of the filter head and an additional outlet port in the very top.  It can be configured with both inlet and outlet on the right, both inlet and outlet on the left, the inlet on the left and the outlet on the right or the inlet on the right and the outlet on the left or any combination with the outlet on the top.  Fuel fittings come in 5/16" (8 mm) or 3/8" (10mm).    You must specify at the time of purchase or you order will be delayed while we contact you to verify size.

When changing this filter element the coolant heating ring is fastened securely and does not separate and drop down from the filter head like other WVO filters.  So you don't have to burn your fingers while you put the whole assemble back together after you crawled under the vehicle to locate the lost seals.  Unlike other coolant heated filters that have neoprene seals that dissolve in WVO and fall apart when you try and change the filter, this filter stays together with a viton seal between the heating ring and the filter head.  We sold the other type years ago and just had to have something better after customers complained when the hot filter fell apart during the filter change.  This filter will NOT fall apart!

We are always willing to help you and will gladly respond to your questions.   

You can also gain a lot of knowledge from this guide:http://reviews.ebay.com/Convert-your-diesel-to-Veg-Oil-WVO-SVO-UCO_W0QQugidZ10000000007415794

Diesel Flow rate is 6-8 GPM and is used on many engines including Diesel School Buses and lots of diesel equipment so the flow is more than adequate for any car or large pickup.

This heated filter unit measures approximately 8 inches by 4.5 inches and can be mounted on the pressure or the suction side of the fuel pump.

Two hole mounting bracket is part of the upper casting with a bleed screw on the top and bottom filter drain to purge water and particulate.

Don't be fooled by other units that use an unpractical wrapped band that heats the outside air more than the fuel and requires you to remove the band and then put it on again every time you change the filter.

Avoid remote oil filter units and household well water filters that have been relabeled for Veg. Oil filters have a bypass and when the filter clogs, the bypass lets unfiltered fuel ruin your injector pump and injectors causing expensive repairs. Household well filters are just that and are not designed for veg.

Shipping to Canada, UK, or Australia can be calculated using the eBay shipping calculator.  If the calculated shipping seems high or for areas outside continental USA, please send your complete address via contact seller and we'll send you an accurate shipping amount.  Purchasing 2 filters are shipped for the cost of 1 filter.  In other words buy 2 and ship for the cost of 1 (your second filter ships for free).

After purchase, please send your email address so we can send you basic operating instructions.

Check out my other auctions for filters, sedimenters, Land Rover items, and 4 cylinder diesel conversions for series Land Rovers, Defenders, Classic Range Rovers, and the Discovery Series I.

If you pay with PayPal eCheck your item will not ship until the eCheck clears our PayPal account which usually takes a week, so don't expect immediate shipping when you pay with eCheck.