Want to make the inside of your car that little bit different, not sure you want to stick to the same colour scheme all the time, or just fancy a few colour change lighting effects to really show off the rest of the mods you have done?  Then this lighting kit is for you - it is RGB Colour change LED strips with an RF type remote control. Quite simply that means that you do not need to find a place to put a cheaper infra red type controller - our controllers are as small as your little finger and can be hidden inside your trim and still work just fine. All you need to do is decide where you want the strips (we give you 1m of flex on each strip to help you find the best place) and then connect the provided power tails to a suitable 12V DC power suppl

This is NOT a plug into cigarette lighter, trailing wires everywhere kit, this kit is meant to be installed inside the trim of your vehicle - so if you are not happy or competent then please either do not buy this kit or get someone competent to fit it for you !!  We will not be held responsible for damage you cause to your vehicle or trim by fitting this kit and either getting it wrong or not knowing what goes back where ! 

Established Ebay Seller with telephone/email/snailmail details for after sales support/enquiries etc.

This kit is not a load of slot together components thrown together - we test every piece to ensure it works right out of the box for you. All wire connections are soldered, all soldered joints are sealed, all seals are neat, all delivered nicely boxed ready to go.

You get :-

1 x 10 Key Simple Remote Control Unit

1 x RGB Controller Module (This is the small little finger sized module located inline which controls the lighting. It is RF type which means no annoying IR sensor to locate, it can be hidden behind a unit, inside trim etc and still work just fine)

2 x 30cm RGB LED Flexible Strips, each attached to the control module with 1m of flex for ease of positioning

1 x 1m Power connection lead with Bare wire ends for you to connect into your power supply - either by connection blocks/scotchlok connectors etc

THIS ITEM MUST BE CONNECTED TO A SUITABLE 12V DC POWER SUPPLY Rated at not less than 1amp