PROKRAFT ACRYLIC PASTE 1 x 10ml

WATCH THE VIDEO HERE: https://youtu.be/ObjYoZDToOM

There is no longer any need for multiple pads, water, towels on lathe beds etc, this specially formulated mechanical abrasive unique to Prokraft is all you need to get a great finish on your acrylic turning.

With a fine finishing cut you may need no sanding at all (at worst 400/600 grit is all that will be required)

How does it work? There are abrasive particles suspended in the paste which get gradually smaller as you polish, so it's like working through different grit sanding but without the hassle, mess and initial expense.

It is easy and very quick, you will go from a dull surface to an initial shine in a few seconds, no special pads we use paper towel!

This is a small 10ml pot however the product is only used in tiny amounts and there should be enough in this little pot to finish over 10 pen kits.

So far we have done 2 pen kits, 2 letter openers and a bottle stopper and we haven't got half way through the pot yet!

This product is also superb for polishing Corian® we have just completed an order for 36 pens and used only 1½ pots - we turned and finished these at a rate of about 10 minutes per pen.

Supplied with instruction / data sheet.

The photos of finished items shown were all finished with NO SANDING.

And when the pot is empty there is a nifty little kit to create something else too!

Finished items pictured are not included.

This listing is for 1 x 10ml pot