12V BLUETOOTH AUDIO MODULE USB MICROSD (TF) FM RADIO AUX MP3 WMA WITH REMOTE CONTROL
• Compact multimedia front-end for use with external power amplifier, such as our Mini 12V 30W Power Amplifier, available here
• Supports Bluetooth, USB drive, MicroSD/TF card and Aux input via 3.5mm jack socket
• Built-in FM Radio
• Simple Bluetooth pair-and-go with Bluetooth device control
• Blue LED display
FEATURE SUMMARY
Manual/Remote controls: Play, Pause, Stop, Prev, Next, Fast Forward, Fast Rewind, Volume, EQ, Single Repeat, Mute, Shutdown, Direct Selection
Bluetooth controls: Prev, Next, Volume, EQ, Play/Pause, Mute, Off
Supported file formats (USB/MicroSD/TF): FAT16, FAT32, MP1 Layer3, MP2 Layer3, MP3 Layer3 32-320 KBPS, WAV, WMA
INSTALLATION
Supply voltage: 7V - 15V (on-board voltage regulator LM7805)
Module dimensions: 107 x 25 x 30mm
Installation slot: 95mm wide
Installation holes: 83 x 20 x 30mm
USER NOTES
With no USB drive or MSD/TF card inserted the module defaults to the last-used mode or Aux at initial startup
Pressing "MODE" on the panel, or on the remote, switches the module into Bluetooth mode: the screen displays "BLUE” and the module is now discoverable as 'LL-BT' or similar.
Pressing "MODE" again on the panel (remote) switches the module into Radio mode: the screen displays the current FM frequency. Press and hold "PLAY" to invoke an automatic channel search.
Pressing "MODE" again switches the module into USB/MicroSD/TF Play mode (depending on the media inserted): the screen displays the elapsed time of the song.
Pressing "MODE" again switches the module into Aux mode for line-level input via 3.5mm jack
Power off memory recalls last played song and volume prior to power off.
NOTE: to pair non-smart phones and some other non-smart devices enter the password 0000 (not normally required)
PACKAGE CONTENTS:
1 x Decoding module
1 x Remote control
1 x two-pin/wire power cable (reverse connection protected)
1 x three-pin/wire audio cable Left/Common/Right
CONNECTION NOTES
With this device:
• The two-pin Power cable should be inserted into the two-pin socket
• The three-pin cable should be inserted into the socket labelled underneath as 'R_out','AGND','L_out'.
• The three pin cable is the stereo signal output cable, which must be connect to a separate power amplifier for output
• 'R_out' is the right signal output channel
• 'L_out' is the left signal output channel
• 'AGND' is the GND/Negative/Earth, it is common to both Right and Left channels, and should be connected to the Right and Left Negative signal inputs of your power amplifier.
Thanks for looking!