The complete
Passive Power over Ethernet SET contains two pieces - INJECTOR and SPLITTER. It
is suitable for using with products that basically do not support Power Over
Ethernet. Passive Power Over Ethernet SET is applicable for wide range of
network products such as Access Points, Routers, IP cameras, modems, switches,
embedded computers or other network devices. Passive Power over Ethernet SET is
compatible with most devices available on the market such as D-Link, Linksys,
Airlive, Senao, Wline, Micronet, Edimax etc. The devices can be supplied
standardly up to 50V. (The power adapter is not included - it is possible
to use the power adapter of the powered device as access point, IP camera etc.)
Passive PoE`s range is normally form 30-40 metres/100-130 ft (the real distance
depends on the power supply, type of cable and powered device).
Complete set for wide range of network products such as Access Points, Routers,
IP cameras, modems, switches, embedded computers or other network devices such
as D-Link, Ovislink, Senao, Wline, RouterBOARD, WRAP boards and other devices
using passive POE injection.
Connector Barrel size is
2.1mm (5.5 x 2.1 mm)
Power Pins 4,5 + and 7,8 -
1. It is very simple to connect a passive PoE. On
the lower part, we connect the Ethernet
RJ connector of passive PoE to the PC, Hub or Switch and connect the power
adapter
to the power socket.
2. On the opposite end (RJ socket) we connect the Ethernet cable leading to the
far end.
3. At the far end, we connect the end of the Ethernet cable to the RJ socket and
connect
the power connectors and the Ethernet to the powered equipment. The equipment is
now
connected by them.
Description :
