Reproduction brake hose for the CB400F and any other Honda with stock width handlebars that have a 1.5" rise or drag bars. If your brake lines are original they should probably be replaced..... It's one of those things you've been meaning to do, now's your chance! This brake hose connects between the master cylinder and the 3 way joint under the headlight (the joint with the brake switch on it).

These fittings are a standard size so they could be used in many different applications. One fitting is straight, the other has approximately a 15 degree angle. If you're running different handlebars than the stock ones, make sure to take measurements before ordering. It's very common for Vintage bikes to have non stock handlebars.

Low bars similar to the stock bars on the '75-'76 CB400F will allow for use of this hose on many different Honda CB's. We have them available here.

We have the banjo bolt available to connect the hose to the master cylinder, as well as new crush washers.

Overall Length: 13.5" (end to end)
Fitting Inner diameter: 10mm (3/8")
Metal Fitting: Zinc Plated Steel

Replaces Honda Part Number: 45126-377-003 (approximately 1" longer than stock)

Fits Honda:

CB400F Super Sport - 1975-1976 (1977 had higher handlebars - measure your current line)

Fits Honda (With Drag Bars or bars with approximately 1.5" rise) - Measure First

CB350G - 1973
CB350F - 1972-1974
CB360K - 1974
CB360T - 1975-1976
CB360G - 1974
CB400F - 1977
CB450K - 1970-1974
CB500K - 1971-1973
CB500T - 1975-1976
CB550K - 1974-1978
CB550F - 1975-1977
CB750K - 1969-1975
CB750F - 1975-1976