Fuser Fixing Sleeve for HP Color Laser jet printer  2550 / 1550

- Compatibility    : HP  Color laser jet  2550 / 1550

- Material   :   special metal + special coating

 Melting point : 384.6 C

- Continuous service temperature : 220~260 C

- Surface Resistivity : 5/10 ~ 6/10 ohm cm

- Surface Roughness : 0.43 Ra micron ,  2.14 Rz micron

- Meet ISO9001-2000, ISO14000 Standard and follow it's strict Quality Control System

- Color  :   natural

- Our sleeve has :

  (1) Longer life-time ; very strong multiple layers of  special coating

  (2) Longer life time in fuser release and repellency ;  much more thicker than others

  (3) Almost permanent off-set free ; an additional electrical conductive layer 

  (4) Precise dimension and cylindricity ; you can enjoy better clearance

      

-Straight from factory, No Middle man; You can enjoy best OEM quality

- Product: Individual carton per each sleeve only

- Condition: brand new in box

 

Grease Not Included

Instructions for Replacing Fuser Film Sleeves

It is very important to apply grease properly when replacing fuser film sleeves. Improper installation will result in no-turning or damage of the film. Please follow the following instructions:

  1. Take off damaged/used fixing film from fixing film assembly or fuser.
  2. Clean surface of heating element using Q-tip with alcohol.
  3. Scoop up grease from the grease container with a spatula, preferably a wooden spatula.
  4. Apply grease to about 15-20 places on the surface of the heater (heating element and fixture). Total amount of grease to apply is around 0.035 oz or 1 gram.
  5. Place the spatula at an angle on the surface of the heater and with one forward and backward movement spread the grease evenly over the surface. Make sure no grease is applied to the surface of the film sleeve.
  6. Slide film onto heater so that the end with grounding ring positions to the same end where in the fuser the grounding conductor is located. Make sure they are in good contact. (There could be different kinds of grounding conductors in different models. Most common one is conductive rubber gear on pressure roller. In such case, the grounding ring should be in the same end and in good contact with the rubber gear.)
  7. Turn the film many times by hands. When you feel film turning is free, you can assemble fixing film assembly with pressure roller.