This is a Graphite Design Red Ice Shaft with the tip installed. It is setup for Long Drive 48 inch length installed. More shaft length= Effortless increased club head speed.
This setup allows you to convert your R11, R9, RBZ Stage 1 or R11s driver into a long drive driver in about 1 minute with your tool.
Tour Accuracy & Distance
70g Shaft in RegularFlex
Will fit all R9 and R11 Drivers all Models including TP and NON TP's
SHAFT with R11 TIP and White UST Velvet Grip.
70g Regular
Plays standard +3 inch length = (48 inches)
This is the USGA Limit. More shaft length = More effortless swing speed.
This shaft was made for Sonartec Golf: See the picture, Sonartec is is small print.
This is for the shaft set up only... This includes the Sleeve and a Grip installed. Ready to install with your tool in a few minutes.
From the grip to the tip of the sleeve is close to 47 inches. Installed the club will be 48 inches (standard TP length is 45 inches).
Made to hit high launch low spin drives. It is new and never hit
Made with the Authentic R11 TAYLOR MADE Sleeve. Aftermarket Sleeves are NOT machined properly and are NOT bored at the correct angle to get the Taylor Made's patiented FCT Flight Control Technology. The Real Taylor Made sleeves are few degrees at an angle on the tip and that is how you can rotate the shafts position and get the different loft, lie, open and closed Face angles. If you purchase any shaft or sleeve setup make sure it is a Real Taylor Made Sleeve, otherwise your shaft configuration features FCT (Flight Control Technology) will not work.
Recent Comments;
Love it. I just hit over 350 Member id justinmero
Great shaft, picked up about 15-20 yds Member id donnap5555