Programming Instructions: This section describes how to learn Keychain Touchpads into Concord Express panels.
To learn ELM Keychain Touchpads into panel memory: 1) Disarm the system to level 1.2) Using an alphanumeric touchpad, enter program mode by pressing "8" + installer /dealer "C" "O" "D" "E" + "0" "0" The display shows SYSTEM PROGRAMMING.
3) Press # and the display shows SECURITY
4) Press A or B until the display shows SENSORS, then press #. The display shows LEARN SENSORS.
5) Press # and the display shows SENSOR GROUP 0. Select the appropriate unsupervised group number (01, 03, 06, 07, 32) and press #. The display shows TRIP SENSOR n (n = next available sensor number).
6) To change the displayed sensor number, select the desired number (1 through 24) you want assigned to the Keychain Touchpad, then press #. The display shows TRIP SENSOR n
7) Trip the touchpad using the unlock button as follows: NOTE: If the touchpad LED flashes two times quicklyanytime during the learning process, stop andstart over again at step 7a.
a). Two quick presses then press and hold until touchpad LED flashes 3 times. Immediately release the button after the third flash.
b). One quick press, then , press and hold until
touchpad LED flashes twice. Immediately release the button after the second flash.
c).Press and hold until touchpad LED flashes once, then immediately release the button. The display should advance to the next available sensor number, after successful learning. Repeat steps 7 a, b, and c until all encrypted touchpads are learned, then exit programming mode |