Emblem WITH Backup Reverse Camera ( Full Color Camera)

COLOR: Chrome

For use with( Years):
Ford F150, F250, F350 (2004-2014)*
*Note- Prior to ordering, measure your current emblem. This replaces all Ford large oval emblems located at the center of the tailgate.

Installation:
This backup camera can be connected to any aftermarket monitor with a Yellow RCA input. Typically the factory emblem is attached to your truck with double sided tape. Use a heat gun, at a low heat setting, and use a piece of floss between the emblem and tailgate to remove the old emblem. On some older models, you may need to drill a small hole in your tailgate to run the wiring through. Most 2006+ models come with the holes already drilled.

Description:

This is an Genuine Ford Emblem (part #CL3Z-9942528-B), aftermarket Chrome base, and  backup camera. For the power supply, you can connect it to any 12V power source. For example, if you wanted the camera to always be on, you can connect it to a 12v source that is on all the time, or if you only want it when you reverse you can connect it to the reverse taillights. Includes video and power extension cable, 8 Meters(26 feet).
*Ford Genuine mounting screws and clips included!

Camera Specs:
Image sensor : 1/4" OV136 CCD Chip
Signal System : NTSC/PAL
Effective Pixel : NTSC: 728 x 582
Minimum Illumination : 0.5 Lux
Video Output : 1.1Vp-p 75 Ohm
Electronic Shutter : 1/50 to 1/100,000 seconds
Resolution : 600 TV line
Angle : 170 Degree
Waterproof Rate : IP68
Current Consumption : 120mA Max.
Power : DC 12V   
Cable Length : Video Cable 8 Meters

Attention!!!:
-Before purchasing check the back of your Monitor/Screen that you have a Yellow RCA input for easy installation.
-Installation is still possible without the Yellow RCA, however it is much more difficult and will require a professional to splice in the Video In signal.