This is a Grafalloy ProLaunch Platinum Lite Senior Shaft Setup to fit the;

RBZ Stage 1 , Driver (Drivers that came with the Green or Red tip) This will also fit all the R9 and R11 models.



This has the grip and 1.5 degree tip installed for a complete shaft setup, ready to install fast with your Taylor Made tool.

Plays 48" The max length allowed by USGA rules.



This 49 gram Grafalloy shaft has a very stable tip and a low 4.0 degree torque with a Mid Kickpoint.

ProLaunch Platinum
  • Mid ball flight counterpart to the original ProLaunch and ProLaunch Red.
  • Built using the fusion of Launch Monitor tuned technology found in the original ProLaunch, as well as the revolutionary Smart-Ply construction found in the Axis shaft. The combination of these technologies results in our longest, straightest composite shaft ever.
  • Proprietary Micro-Mesh tip technology provides lower torque for greater stability while offering superior feel at impact compared to other low trajectory, tip-stiff composite shaft designs

Smart-Ply™ Technology
  • Smart-Ply™ technology preserves 100% of the carbon fiber properties by incorporating only unidirectional, low FAW, high-modulus fiber.
  • These unidirectional fibers are then strategically placed in multiple axes along the full length of the shaft resulting in unequalled design consistency and material integrity / performance.
  • Grafalloy’s proprietary System 9 design model computes over 40,000 calculations per shaft ensuring unparalleled accuracy in material placement and lay-up.

Attached Image: monthly_03_2008/post-24339-1206533350-1.jpg
Attached Image: monthly_03_2008/post-24339-1206533351-3.jpg


  


This is for the shaft set up only... This includes the Sleeve and a Black  Grip. Ready to install with your tool.

From the grip to the tip of the sleeve is just shy of 47 inches  inches. Installed the club will be close to 48 inches (standard is 45-46 inches).

This is for the shaft set up only... This includes the Sleeve and grip. Ready to install with your  tool.

Made with the Special Authentic TAYLOR MADE Sleeve from. Aftermarket Sleeves are NOT machined properly and are NOT bored at the correct angle to get the Taylor Made's patiented FCT Flight Control Technology. The Real Taylor Made sleeves are few degrees at an angle on the tip and that is how you can rotate the shafts position and get the different loft, lie, open and closed Face angles. If you purchase any shaft or sleeve setup make sure it is a Real Taylor Made Sleeve, otherwise your shaft configuration features FCT (Flight Control Technology) will not work.