Complete set of four wheel arch liners.

Following on from the ever popular 3D printed version, these are now manufactured in ABS sheet. Better finish, stronger, and at a greatly reduced cost!

These are the perfect finishing touch for shelf queen and runner alike. Give your Scorcher the scale looks it deserves at the same time as protecting the inside from the worst of the wheel spray.

Please note, parts are supplied UNTRIMMED, unlike the pictured finished parts. Trim to your own requirements and preference. Please use the pictures as a trimming guide to suit the Sand Scorcher.

Use of small curved lexan scissors is highly recommended, if not essential to make the job easy. See link at the bottom.

Flanged fit to the body offering a very tidy attachment. The great fit was developed from digital scanning of the Tamiya shell and chassis.

For the best attachment, use a good quality epoxy glue to glue the parts to the body.

Primarily designed for the Sand Scorcher, but will also fit Monster and Blitzer beetle shells, or any custom build, albeit with your own own custom trimming.

Great feedback from previous buyers:

"great fit to vintage and re-release alike".

"If you own a scorcher,then you need these! Look fantastic!"

See other cool Scorched Parts products on the Shapeways website!

Lexan scissors.... order a set now, they are a great little tool:

https://www.ebay.co.uk/itm/Scissors-Curved-RC-Cutting-And-Trimming-Lexan-Polycarbonate-Bodyshells/252502076294?hash=item3aca4beb86:g:YWMAAOSwiYFXJVKa