4 x WBT 0730.01 (2 x red + 2 x white)
Product for the highest demands on signal transmission, mechanics and design
Excellent mechanics, solid construction and the two-part clamping nut with freely rotatable pressure piece enable high contact pressure and thus low, constant pressure Contact resistance- the prerequisite for minimal sound influence. The elegant design of the pole clamp is supported by the gold-plated high-gloss surface, which prevents any corrosion.
The pole clamp is polished before gold plating, so that a highly durable and abrasion-resistant surface is created.
External connection
>> 4 mm banana plug
A 4 mm banana plug can be connected to the front part of the clamping nut.
>> Cable lugs and crimped cable ends (up to 6 mm²)
With the patented clamping nut system from WBT , cable lugs and crimped cable ends can be connected with high pressure. Thanks to the paving of the pressure piece base, the connection is permanently held securely with very little contact resistance. Cable strands are also prevented from shearing if bare cable ends are used.
Internal connection
Inside, cables up to a conductor cross section of 10 mm² can be used.
WBT recommends the Crimp termination technology. With the included Torx screws
and the Torx T.6 key, crimped cable ends can be perfectly fixed.
However, the connections can also be soldered. WBT then recommends the gentle on the surface Silver solder WBT-0800
Installation
Installation insulations are supplied, which, in addition to the insulated, also ensure torsion-proof installation and pole identification. This also includes lock nuts, Double step discs
with nose and puzzle slices. These puzzle slices can be clipped together. This results in precise terminal clearances of 19 or 30 mm, but above all an absolute protection against rotation.