Key Features:

Finally you can convert your UM2 / UM2+ to go with 1.75mm filament! You have the choice to install it in the 2nd block position (UM2), or just replace your existing block. If you have a UM2+, you need a new fan shroud with 2 holes. If you put it in the second position, you can have both setups in parallel. With this setup you will need to add a Heater and PT100 temp sensor. We recommend the 35W heater and PT100 by 3D Solex (sold separately). You can have both the old and new block installed at the same time.

Item Specifics
1 - Conversion kit
Fits: Ultimaker 2 & 2+