Waterslide Decals Nasschiebebilder 1:18 Ferrari 412T2 V12 1995 J.Alesi car livery + fill in tobacco suit/helmet

Due to added government tax prices are altered. For more questions. Feel free to contact me on decals123@outlook.c.m or FB or Kleinanzeige

Combined shipping possible up to 3 decals at once. You only pay portal costs for the first object. Just place your order, I adjust the total shipping costs for you to the €3,98 worldwide shipping

To convert your 1:18 car. This decalsheet is for converting 1 car + fill in for helmet and suit.

Shipping worldwide with post stamp. Shipping is at buyers risk because of this private sell. No warranty or refund.

If you buy this item then you agree to the terms of delivery of: no warranty, refund and damage/loss during Shipping. If not agreed to these terms of delivery DO NOT BUY.

At the buyer's costs it can also be shipped insured with tracking. 

Netherlands 8,30

European Union 14,65

Worldwide 27,90

Colors may differ from image

HOW TO APPLY THESE WATERSLIDE DECALS:

* Cut out the image(s). It's the best to use a sharp knife and a cutting mat otherwise a sharppair of scissors.

* Release the decal by placing it in a bowl of water for 20-30 seconds. If you are not about to use the decal rightaway you can also dip it and place it on a dish in a drop of water. Optionally adding a bit of Microset will help adherance and improves the release of the decal.

* Meanwhile make sure the surface is free of dust. Optionally clean it with a degreaser like ammonia, rubbing alcohol or a universal degreaser.

* Apply the decal to the surface by sliding it from the backing paper directly onto the surface. Position the decal to your liking.

* Remove any trapped Air by pushing these aside with your finger. Also remove excess water by carefully rubbing it with a damp tissue. If you have a squeegee it is the best to use for this stage.

There are 2 options for finishing.

1 the regular "cold" method.

2 the bake-on method which is for glass, ceramic and metal.

1 the regular "cold" method.

* Leave to dry for at least 12 hours. The temperature/setting is depending on what the surface can handle. If you do not use Heat you can at this point apply Microsol to make it settle onto the surface better.

* When the decal is completely dried it is the best to clear coat it and the object with a acrylic varnish/lacquer. By doing so IT will enclose the decal and make it with the surface, so it can not come lose anymore.

2 the bake-on method which is for glass, ceramic and metal.

* On glass, ceramic or metal the decal van be baked-on. This can be done with a hot airgun but it is better to use An oven. Depending on the oven, the object and the size of the decal the settings need some experimenting. As a guide use 180 degrees Celsius to a max, of 230 degrees Celsius for 10 to 30 minutes. In general using 200 degrees Celsius for 15 minutes is a good starting point.

NOTICE.

The usage of this material, tools and other auxiliaries is for your OWN RESPONSIBILITY.

Due to added government tax of 21% prices are altered. For more questions. Feel free to contact me on decals123@outlook.com or FB or Kleinanzeigen.