- Cutter Height : 10mm (If you need the cutters deeper please contact me and I can make the cutters to your requirement)
Hope you have fun getting creative.
RECOMMENDATIONS :
- A stiffer clay would be easier to work with while cutting out the clay with 3D printed cutters to get a firm cutout edge.
-
If you are living in a hot and humid climatic condition, then sometimes
your clay can sticky. To avoid your clay getting stuck inside the
cutters, place a piece of cling wrap on top of your roller out clay and
then use the cutters to cut out the shapes. Or you could also work your
clay with corn flour or polymer clay powder before pressing the cutters
into the clay
- Apply pressure firmly and evenly on to the cutters to
press down the clay to cut all the way through. Don’t apply sideways
pressure as this would distort the clay shape.
- Usually 3D printed
cutters don’t give a clean cut so once you remove the cutters from the
clay, make sure to trim the edges if there is any excess before backing
so that you spend less time sanding the pieces.
CARE INSTRUCTIONS :
- The material of the cutter is PLA Eco Plastic so keep away from heat temperature higher than 70 °C
- Wash before first time use.
- Hand wash only.