• Memory

♦ 256MB standard SDRAM soldered on the board

♦ 100MHz Clock Speed

♦ 512kB boot block Flash device

• Interface Buses

♦ PC/104 and PC/104-Plus Bus Interfaces

♦ PC/104 Bus speeds up to 8MHz (16-bit ISA Bus)

♦ PC/104-Plus Bus speed at 33MHz (32-bit PCI Bus)

♦ PCI 2.2 compliant

• IDE Interface

♦ Supports two enhanced IDE devices

♦ Supports single master mode

♦ Supports Ultra DMA 100/66/33 in master mode

♦ Supports ATAPI and DVD peripherals

♦ Supports IDE native and ATA compatibility modes

• CompactFlash Adapter Socket

♦ Supports Type I or Type II PC cards

♦ Supports IDE CompactFlash card

♦ Supports bootable CompactFlash card

♦ Supports primary IDE with Master/Slave jumper

♦ Supports +3.3V or +5V PC cards (voltage selection jumper)

• Utility Interface

♦ Floppy Disk Interface

• Supports one floppy drive (Shared with Parallel Port)

• Supports all standard PC/AT formats: 360kB, 1.2MB, 720kB, 1.44MB, 2.88MB

♦ Parallel Port Interface

• Supports standard printer port (Shared with Floppy Disk Drive Port)

• Supports IEEE standard 1284 protocols, and EPP, ECP outputs

• Bi-directional data lines

• Supports 16 byte FIFO for ECP mode.

♦ Serial Port Interface

• Supports two RS232 serial ports with full handshaking

• Port 1 supports full modem capability and RS485

• Provides 16550-equivalent controllers

• Supports two 16-byte FIFO buffer

• Supports programmable word length, stop bits, and parity

• Supports 16-bit programmable baud-rate generator

• Supports an interrupt generator