> Exhaust mounting paste VISBELLA
> Paste for cracked car exhausts / thermo silicone type / for lubrication of gaskets and connecting units of mufflers up to + 1100C.
> Resistant to monoxide gases and high temperatures up to 2012 ° F (1100 ° C).
> Easy to use
> For direct use
> Curing time: 24 hours
> Packaging: 150 ml
> Color: gray cream paste
> Non-flammable
> Iron-reinforced
Directions:
1. Surfaces must be clean, dry and free of dirt, grease or oils.
2. Wet the surface to be repaired with water.
3. Apply the sealer directly over the hole.
4. Allow to dry for 30 minutes and let engine run for at least 10 minutes once dry before you drive.
5. For new installations, apply the gum around inside of the larger pipe. Complete and seal the connection.
6. Clean up with water prior to material drying.
Warning: Avoid contact with eyes, skin and mouth. Use in well ventilated area. In case of contact with eyes, flush with water immediately for 15 minutes. If irritation persists, seek medical attention.
How to use:
1. Clean all grease and dust on the surface of the exhaust pipe.
2. Spread the exhaust pipe glue evenly on the surface of the area to be repaired.
3. Wait for it to dry at room temperature for at least 24 hours (if the hole range is over 0.5 cm, it should be used with wire mesh).
4. Heat curing for 15 minutes (if the surface is bubbling, it should be scraped and reattached).
Attention!
Store in a cool, dry place. Protect from frost. Store in temperature below + 25 C.
No dangerous vapors is generated.