eBay

This is a TRAXXAS SLEDGE compatible rear handle.

Adds a comfortable carrying handle for transportation of the SLEDGE.
Made of nearly indestructible high temperature Nylon.
Offers some addition protection to a rear landing.
Handle is 10cm wide. For reference, it is my hand in the auction pictures and I am a 6'3" man.
No permanent modification to car required.
Does not interfere with wing or other car operation.
Easy to install.
Auction includes the handle all required hardware.

Check out the ReactionRC store for other upgrades and discounts.

Installation:

*Refer to auction images for installation locations*

Remove the 4 screws going through the rear shock tower and into the rear body mount. Place washers on the included 18mm m3 screws. Orient the handle with the rounded corners near the screw holes oriented up. Thread the screws through the holes on the handle and into the holes previously opened. I recommend not tightening everything down until all the screws are in place and the handle is straight. Take care not to over tighten the screws. Feel free to message me if you have any questions. Thank you.

This is a custom ReactionRC part and not associated with TRAXXAS.