PRE CUT CLEAR BRA PAINT
PROTECTION FILM FOR: Chevrolet Silverado 1500 (2019-2021)
See compatibility list for
sub models
PRE CUT KIT COVERAGE: Grille & Front Bumper
Factory Crafts uses ORAGUARD
270 Stone Guard Film it is Medium-term paint protection for automotive fenders,
rear bumpers
and deck or side skirts, and
other outdoor applications. Use on flat and slightly curved surfaces. Digitally
cut with the latest
PPF data software for the
perfect fit. PPF needs to be stretched for installation so you may see it short
if just laying it out on car.
INSTALLATION
INSTRUCTIONS
The
vehicle base should generally be cleaned with conventional cleaning agents. Do
not use substances attended to form a coating or sealing layer by means of
nanotechnology on the base to be cleaned.
a)
Clean the vehicle.
b)
Thoroughly check surfaces and edges for residues of preservative wax or
polishing agents and remove them with industrial cleaning agents or silicone
remover (isopropyl Alcohol alone is not effective).
c)
Finally, the surfaces to be bonded must always be cleaned with isopropyl
Alcohol. This will remove most efficiently all residues of previously used
cleaning agents (spirit is not recommended).
d)
Thoroughly dry the vehicle, use hot air blower to remove any residual moisture,
particularly moisture trapped under rubber seals.
Note:
Solvent residues due to improper cleaning or a recent paint job may result in
blisters forming between the film and the base and affect adherence. Make sure
that films are only bonded to completely dry and hardened coating finishes. As
a rule of thumb, allow a minimum drying period of three weeks.