Slimline Ecoheater Tubular Heater

Available in 6 lengths (approx):

HHT203 - 300mm - 28W

HHT205 - 500mm - 55W

HHT207 - 750mm - 90W

HHT210 - 1000mm - 120W

HHT215 - 1500mm - 190W

Ideal for use in a wide range of areas including Conservatories, Greenhouses, Sheds, Garages, Lofts, Cellars, Mobile Homes, Boats, etc

This slimline tubular heater is ideal for preventing damp, mould and mildew, condensation and moisture build up in a wide range of environments including built-in wardrobes, airing cupboards, conservatories, sheds, garages, caravans, mobile homes, boats, shop windows, portable buildings, pet enclosures and many more. It provides a gentle, constant heat to keep spaces aired. 

The Ecoheater is the only tube heater on the market that was be used floor standing or wall mounted, and that features a built-in thermostat to keep energy usage to a minimum. 

These heaters are manufactured to be a high quality seamless tube with an easy to clean white enamel finish and feature an automatic heat sensitive cut out. 

Using the Thermostat

1) Turn the thermostat knob in a clockwise direction until it reaches the maximum setting 

2) When the room has reached the desired temperature, turn the thermostat knob in an anti-clockwise direction just until the appliance switches off (amber yellow light goes out) and not beyond.

3) The temperature will then be regulated by the thermostat

4) To reset, disconnect the heater from the power source for a few minutes to allow the unit to cool down.

Features

IP44 Weatherproof Rating (safe to use if sprayed or splashed with water)

Supplied with brackets for wall mounting or floor standing operation

Fitted with a 1.5m long cable and standard 3 pin 13A UK plug top

CE Approved - Complaint with BS EN 60335/1:2002

*Please note: When the heater is used for the first time, small whisps of smoke may appear from the heater. This is a normal part of the first time operating procedure and should cease after the heater has been in use for approximately 5 minutes*

Also Available - Replacement Pair of Brackets/Feet (Please note: These are supplied without fixings so suitable screws will be required as detailed below) 

2 screws will be required to secure the 2 parts of the brackets together. We recommend 1" flat head wood screws.

You will also require 4 suitable screws (and maybe rawl plugs) to fix the brackets to the surface where you want to mount the heater.

Wire Guards Also Available in Our Ebay Shop