Replacement hot end Nozzle Assembly for Flashforge Finder (Original) 3D Printers
Please note the Finder 3D printer has two possible voltages 12V or 24V please refer to the final image to decide which you need.
Please note that this is not suitable for Finder 2 versions using the later bead type thermistor. please check before purchasing.
Comes assembled
1 x 0.4mm nozzle
1 x heatbreak with PTFE tube
1 x Heater block
1 x Thermocouple
1 x Cartridge Heater
1 x Heat insulation sheet