4 in 1 charge/Discharger(boost)/battery protection/Battery level indicator modules
DD06CVSA is a multifunctional 3.7V/4.2V Mobile Power Diy module,3 in 1 Function: charge,discharge and battery protection.
It is very suitable for DIY mobile power.
Charge voltage : DC 4.5V-5.2V(If the power supply is 5.2V-5.5V, please parallel diodes (eg SS34 SMB))
Charging current : 0-2.1A
Charge quiescent current : 100uA
Full charge voltage : 4.2V+-1%.
Discharge current : 0-3.5A;
Discharge quiescent current : 50uA
Discharge conversion efficiency : maximum 96%
Output voltage : 5V
Output current : 0-2.1A;
Operating ambient temperature : -20° to +85°
Size : 26.7 x 18.1 x 5.7mm
Weight : 1.9g
Comes with battery protection, do not need battery protection board
(if your battery comes with a protective board, it does not matter)
Overcurrent protection(OCP)
Overvoltage protection(OVP)
Short circuit protection(SCP)
Over temperature protection(OTP)
Pin description:
1 VIN : Charging port +
2 GND : Charging port -
3 BAT : Battery port +
4 GND : Battery port -
5 GND : Output port -
6 VOUT: Output port +
7 KEY : Output trigger port(Low pulse trigger)
1 In discharge mode(In the charging mode,the KEY function is invalid),
the KEY Trigger once,turn on the output;Continuous trigger twice: turn off the output.
2 When the load access, it will automatically turn on the output.
But if the load is less than 50MA, the output will be turned off after 30 seconds
3 While charging, while discharge, it is allowed
NOTE:
If the output load current is less than 50MA, turn off the output after 30 seconds.
If the output load current is greater than 50MA,continuous turn on the output