DC 24V 1 Key Fob Control 2 pcs 1 Channel RF Wireless Remote Relay Switch On Off
 
QTY: 2 pcs 1 Channel receiver contrller and 1 pcs 2 button handsender . (This remote doesnot have a battery inside )
 
 
 
 
Receiver :

 

Technical indicators:

 
Working voltage: DC24V;
Operating frequency: 433.92MHz;
Receiver sensitivity:-95dB;
Encoding: Receiver Recording;
Momentary / Latch / Toggle selectable (defult is Momentary , Latch Mode need 2 buttons handsender );
Output mode : Relay switch;
Receiver size: 62 * 35 * 22 mm;
Max load : 500W;  
 
Advantage :
1:  Receiver Mother board have a learning key , if the remote is lost , must buy EV1527 remotes to re-learn;

Output:

 

Work mode (programmable )
singnal Inter-locking (Latch)
singnal Self-locking (Toggle)
singnal Non-locking (Momentary is defult )
 
 
Program steps : 
1: keep pressing learning key on the receiver controller , 
LED turn on after 2 second , then turn off after 4 second, then the receiver controller enter programming state , but not release the finger , still keep pressing the learning button ,
LED blink once after 2 second , release the finger on learing key , it is Momentary mode ,
or still keep pressing learing key , 
LED blink twice after 2 second , release the finger on learing key , it is Toggle mode ,
or still keep pressing learing key ,   
LED blink 3 times after 2 second , release the finger on learing key , it is Latch mode ,
 
 
Learning method and steps

   Keep pressing learnig key on receiver controller board , LED turn on after 2 seconds , release the finger on learning key , press the key on remote , work state LED blink 3 times , it means learnig successfully  ;

Clear the deposit information

      Keep pressing learnig key on receiver controller board , LED turn on after 2 seconds , then turn off after 4 seconds , it means clearing successfully .

 Relay mode :
Normally close (NC ) ;
Normally open (NO ) ;
  • Normally-open (NO) contacts connect the circuit when the relay is activated; the circuit is disconnected when the relay is inactive. It is also called a Form A contact or "make" contact. NO contacts may also be distinguished as "early-make" or NOEM, which means that the contacts close before the button or switch is fully engaged.
  • Normally-closed (NC) contacts disconnect the circuit when the relay is activated; the circuit is connected when the relay is inactive. It is also called a Form B contact or "break" contact. NC contacts may also be distinguished as "late-break" or NCLB, which means that the contacts stay closed until the button or switch is fully disengaged.
 
 
Transmitter :

 

 

 

Technical Data :
Transmitter Module No.: YK004 -2 2 Chanels
 Power supply : 12V 27A battery  replacable .(This remote doesnot have a battery , Please buy in on local market )
Operating current: ≤ 12mA;
Oscillation mode: SAW resonator;
Modulation mode:ASK;
Operating frequency:433.92MHZ ;
Frequency deviation:±0.2MHz;
Encoding format: Learning Code ( EV1527 ) . Cannot cloning or copy any remotes ;
Transmit power:10 mW.
Data Rate : 50~60KHZ;