Good for all refrigerants including high pressure refrigerant.
If you own a refrigerant/refrigerant recovery/recycle unit then you know how important it is to take care of it.
Recovering gas from a "burn out" or "shorted to ground" system can cause a ton of damage to the recovery machine, your hoses and your gauges.
If your going to recycle the gas for reuse you must use a Filter-Drier made for burn outs.
These special driers, known as "HH" or "BURN-OUT DRIERS" can remove dangerous acids that can damage your tools and equipment or the system itself, if you are going to recharge the system with the burnt out gas.
Once you have the kit you can buy just the filter-drier.
This is a large drier, it is actually 3/8" male flare and comes with the 3/8" Female Flare x 1/4" male Flare adapters so the regular hoses can connect to it.
The Filter is the "HH" style, Part# EMERSON, BOK-163HH, PCN: 060241
SID# D14-110
2 - #W3-63
Most of the damage that occurs to recovery units is from foreign material entering the recovery unit and damaging the compressor.
If your recovery unit has a ""OIL-LESS" compressor, it is even more critical that you prevent foreign material from entering the unit.
Now comes the dilemma that some recovery owners face.......there is simply not enough room to screw on a pre-filter and then your hose, or you have to use a expensive male x female pre-filter.
This kit takes care of both of those problems.
It uses a STANDARD 1/4 x 1/4 male filter, you can use ANY size filter as long as it is 1/4" male flare.
The extension hose that COMES WITH this kit allows for some room between the recovery unit inlet and the pre-filter.
INCLUDES;
1/4" Male x 1/4" Male "BURN OUT" Pre-filter
6" 1/4" x 1/4" Yellow Extension hose with swivel ends.
(2) 1/4" Caps with Straps to keep the filter clean when not in use.
(2) 1/4" Male "Screw-in" plugs to keep the hose clean when not in use!
Protect your expensive Tools and Equipment with this inexpensive kit!!