450nm 20W/30W/40W Engraving Laser Module 3D Printer DIY Cutting & Marking
Wavelength: 450N (+-8NM)
PWM TTL modulation signal: 0-5V, frequency:<20 kHz
Laser
working voltage: 12V (24V can be customized. If 24V is needed, please
make a note in the message or contact the customer online for
instructions!)
Focusing method: 20W is adjustable, 30W and 40W are fixed focus, with a focal length of 2CM, not adjustable!
Please keep the 20W zoom range about 2-8CM away from the object plane
size (excluding fan): 40 * 70mm, 60 * 80mm, 33 * 130mm
20W, 30W, and 40W are all electrical power!
Notes on wiring:
This product is equipped with one 3-to-2 * 2PIN cable, one 3PIN cable, and one power cable for connecting DC to 3PIN.
The
red and black wires are used for connecting to 12V or 24V power
sources, with the red wire connected to the positive pole of the power
source and the black wire connected to the negative pole; The yellow and
white wires are used to connect 0-5V PWM or TTL signals, with the
yellow wire connected to the positive pole of the signal and the white
wire connected to the negative pole of the signal. When connecting your
device, please be careful not to connect the wires backwards or
incorrectly, otherwise the laser will not light up and only the fan will
rotate. Please be aware!
In addition, the DC to 3PIN power
connection cable can be connected to the DC male adapter of 5521 or
5525, directly connected to the socket for use!
Applications:
This laser can carve wood, bamboo, non transparent acrylic, bones, colored plastic, etc.
40W can cut thin plywood up to 5MM (speed needs to be adjusted to 150MM/MIN, repeated 1-2 times, if you need to cut quickly, please do not purchase this), cardboard and other materials.
It is not allowed to carve transparent, reflective, or mirror materials or metals.
Package:
1PC 450nm engraving Laser Module