This item located in Czech Republic and only shipped to European countries,
If you need to return the item for some reasons, please contact us via eBay message firstly to get the RMA#,and return address instead of sending iit back directly without permission,thank you!
GODIAG Full Protocol OBD2 Jumper for E-CU Prog/raming
Full protocol OBD2 jumper is used to connect E/CU for E/CU prog/ramming via OBD2 way.
Product Functions:
1. Supports DC power supply
2. Support safety protection banana head super coding dedicated connection port power supply.
3. Independent GND4, GND5 [meet the needs of special E.CU coding].
4. With boot GND4 clip, compatible with coding equipment .
5. With GND4 GND5 short-circuit switch [some E.CUs need to be switched to short-circuit mode when coding].
Note: The switch of GND4-5 is normally pressed to make it light. When some E.CUs need to be independently connected to GND4 and GND5, release the switch.
6. With ignition analog switch [equipped with 1 large and 2 small dedicated ignition cables].
7. Support standard obd2 full protocol connection [double K line, double CAN line], 3 large and 2 small power plugs, 4 large GND, 4 small GND.
8. Equipped with CAN protocol communication resistance.
Connection diagram of the dedicated coding power connector.
Connection diagram:
E.CU connection diagram:
What is the analog ignition switch?
After the ING ignition switch is pressed, the line marked with ING12V will have 12v, which is the analog ignition switch. Because when some devices read some E.-CUs, the device will prompt to turn on or off the ignition switch.
Package Includes:
1pc x Full protocol OBD2 jumper
3pcs x Electrical resistance
