Product features:
1, High input voltage, stable voltage output.
2, Support over-temperature protection, over-voltage protection, short circuit protection.
3, Low power consumption; with heat sink, good heat dissipation.
4、Support constant voltage and constant current output.
5、Support charging function.
6、Products can be applied to general power supply, battery charger, LED driving power supply, power conversion.
Product Description:
It is a DC constant voltage and constant current step-down power supply module. It can be used as an ordinary step-down power supply module, charger and LED constant current driver, simple, efficient and practical.
Product Parameters:
Product name:DC step-down power supply module
Operating voltage:DC 16V-90V, DC16V-120V, DC 9V-90V, DC 9V-120V (keep input at least 4.0V higher than output)
Output Voltage:DC5V, 12V
Output Current:3A
Output power: 5V-15W, 12V-36W
Conversion efficiency: about 96% (the smaller the differential voltage, the higher the efficiency)
Operating frequency:140KHz
Soft starter:Yes (Failure under high power load)
Over temperature protection:Yes
Over-voltage protection:Yes
Short circuit protection:Yes
Operating Temperature Range:-40°C~85°C
Operating humidity range:0%-95%RH
Size: about 42*30*18mm
Steps of use: 1.
1.Wiring:IN+ is input positive, IN- is input negative; OUT+ is output positive, OUT- is output negative.
2.Connect the connecting wire between the module and the power supply first, and then power on. Remember! Remember! (If the input side of the wiring with electricity, it is easy to fire phenomenon, especially when the input power supply voltage is high, and even burn the module's pads).
3. After selecting the appropriate power supply, use a multimeter or voltmeter to measure whether the output voltage of the module is consistent with the voltage required by the equipment.
4. Connect the electrical equipment or (load) to the output of the module.
Caution.
1.This is a step-down power module, so please keep the input at least 4.0V higher than the output.
2.Input and output are not isolated for safety and reliability.
Product List:
1X Buck Module