Mute 2-6S 20A x 2 Two-Way Bi-Directional Brushed Hybrid ESC

Features:

l This ESC is designed for high-current 540 and 550 motors, and can be a good helper for you to change big tanks and big boats

l Dual-hybrid ESC have mixing mode, dual-channel independent and dual-channel synchronized modes

l With runaway protection, power-down protection, overheat protection, no overcurrent protection

l Power switch can be soldered on the back, the power switch works on the BEC at the same time, so it switches the power supply to the receiver at the same time, even if the switch is turned off the ESC still consumes a small amount of current, and the battery must be unplugged if it is not used for a long period of time

Specification:

l Size: 50x34mm

l Quantity: 1 PCS

Parameters:

l Suitable voltage 5v-25.5v (can use 2-6S lithium batteries)

l Mute: Eliminate the annoying drive noise, this noise is especially obvious when the motor does not rotate or low speed (you can also return to the non-mute mode through the back of the solder joints, see the back of the description)

l Current: Single 20A Dual is 20Ax2 (If you know your own motor, you can also connect 795, 895 and other motors, most of the motors are less than 20A, don't be misled by the labeled hundreds of A ESC)

l Applicable motors: ESC is suitable for motors with higher current, if it is a small-current motor with dense winding, the maximum throttle may appear instead of a sudden decrease in speed. (If the user is willing to test the small current, please bear the return postage, and ensure that the product is intact)

l 6S lithium can use 288W 775 double roller bearing motors (using 24V power supply, each circuit current 10A more)

l 3S lithium can be used 540 550 high-current motor; 150W 775 double roller bearing motor ( including the following levels )

l Remote control center point fixed PWM 1500us (+50 -50), travel minimum 700-1100 and maximum 1900-2300 auto adaptive

l With neutral point start (power on will "beep", to the neutral point of 1500, will "beep" twice, ESC start)

l Can set the neutral brake, initial strength, linear parameters, ESC default settings to meet the novice, veterans see later Advanced parameter setting methods

l BEC: 5v 2A long run, 3A peak (use ubec high efficiency conversion program for this product)

Package:

l 1x ESC

l Note:

l The receiver is not allowed to supply additional power, if you want to supply additional power (such as connecting the flight control with bec or other ESC), please cut the red wire in the 3P white-red-black wire of the ESC)

l The overheat protection can only be effective when both channels are used, otherwise, it is difficult to make the protection effective when only a single ESC is used with uneven heating and cooling

l Motor+- In addition to connecting the C104 anti-interference capacitor, can not be connected to other capacitors (such as: 2uf or more capacitors)