ColorFill worktop jointing compound is formulated to seal and joint worktops and surfaces at joins and mitres, it will provide a near invisible join and can also be used for small repairs to the laminate surface.

• This ColorFill worktop joining sealant is supplied in a 25gm tube.
• Each tube is enough to seal one 60cm join, breakfast bars and other long joins will require additional tube of colour fill.
• Use for Kitchen Worktops & Laminate Floor Repairs
• Joining Kitchen Worktop Mitres

Application for worktop mitre joint:-

Apply a thick bead around the leading edge of the joint to both the bottom and the top of the exposed core taking care to ensure adequate sealaant around the front and back edges and the bolt slots. Quickly close the joint and allow the excess sealant to squeeze out of the joint, align the two sides and tighten the bolts fully. It is important that the joint is closed quickly as the sealnt will start to set immediatley. The excess sealant should be removed with a spatula which should be drawn towards the front edge from the back of the worktop applying pressure down and into the joint, thus ensuring there are no air holes along the top of the joint. Clean off the remaining surplus sealant with a solvent moistened tissue taking care not to dislodge and colorfill still setting in the joint. Clean across the joint at 90 degrees to the cut at all times, to ensure a perfect finish a final coat may be applied later if necessary. Colorfill should not be mixed or combined with any other material in the joint.

Application for repairs to damaged surfaces:-

Clean the damaged area with a solvent moistened tissue to ensure there are no oil or grease residues on the surface. Clean across the area with a spatula to remove any small chips or fragments. Select the correct colour and squeeze out a liberal amount onto the edge of a spatula. Position the spatula behind the area to be repaired and press firmly down on the surface pulling the spatular towards you, filling the area with colorfill.

Finishing off:-

To clean off the overfill, use a solvent moistened tissue around the repair taking care not to clean out the filled area. Do not mix solvent with colorfill and only wipe around the damaged area, not in it or the material will be dislodged in this early stage before setting. Using a spatula, scrape off the overfill from around the damage and draw the spatula across the damage to ensure that all overfill has been removed. It is important to keep the spatula blade perfectly clean to ensure a smooth finish. Colorfill is a one component product and may shrink slightly during drying. Depending on the result, a second or third coat may be necessary to build up the depth. Clean off the overfill between each application, for final clean up, allow 24 hours to fully harden and clean the area with household washing up liquid and warm water.


Colourfil tube and solvent included in price!