22.5" truck tire changer Pneumatic portable tire changing machine

 
Product Parameter:
Working Power: Pneumatic
Working pressure: 0.8-1.2 Mpa, 116-174psi
Rotating speed: 1 rpm/ 12 sec
Application Hub: Standard R22.5 inch series /17.5-19.5 inch series (optional) /16 inch series (optional)
 
 

 
 
Introduction of tire disassembly and assembly machine：
1.The height of the tire disassembly machine is low (specially designed according to the diameter of the tire). It is a bit labor-saving when placing the tire. It can be placed in place with a light push.

2.The power train is equipped with a muffler to reduce noise while the power is not affected. The fuselage is small in size and light in weight, and can be moved by one person, so that the tire changing operation can be realized when going out.

3.The shovel tire trowel undergoes multiple processes such as cutting, tempering, rough grinding and fine grinding. The shovel tire shovel has high strength and does not deform. The surface smoothness of the shovel head reaches the mirror level. The shovel tire is guaranteed not to hurt the tire mouth.

4.The angle design of the tire loading arm has been simulated by the computer for many times. The design angle is very reasonable, and the tire will not be injured during loading.

5. The design of the tire fixing point is reasonable, and the tire can be fixed only by gently rotating, eliminating the trouble of disassembling and screwing, and saving time.

 

Use warning：
1. Before removing the tire and installing the tire, the grease must be evenl applied on the tire mouth, otherwise it will easily hurt the tire mouth.
2. Before tying the tire, use a shovel to shovel the tire mouth, and squeeze the tire rod as flat as possible, so that the shovel head and the steel ring have a gap of 0.5 cm. Damage the device.
3.The machine should not be exposed to rain to avoid damage.
4.The air compressor should be drained regularly to prevent a large amount of water from flowing into the motor and causing damage to the machine.


Maintenance methods：
1. After using it a few times, be sure to check the tightening of each fixing screw. Each screw must be re-tightened. Regular inspections are required in the future to prevent the screws from loosening and damaging the device.
2. The tire picking device and tire mounting device should be smeared by the police to prevent rust.
3. Regularly fill with wind gun oil.
4. Maintenance of the machine head: after removing the inner connecting shaft, add grease into it and turn the machine to lubricate the gears. 

 

 
Composition of tire disassembly and assembly machine:
Tire loading operation method：

Method of tire dismantling operation：

 
Item Number:

22.5" Pneumatic tire changing machine  (239769)
 

On Jan 18, 2024 at 00:19:09 PST, seller added the following information:

DataCaciques