This device is used for removing/replacing X-Metal sunglasses’ Pin (rivet), Flex Coupler. It is a hand-operated device. It is compact and it can provide a stepping stone from amateur to professional X-Metal owner.
You will be able to push out the nosebridge rivet of the Oakley X-Metal frames
which allow you to change/replace the rivet itself and/or just the flex coupler. To work easily, please remove the sunglass
ear stem (arms) before proceed to change/replace the coupler/pin because it
provides a space to handle easily.
When installing the pin, proceed slowly with care and do not push forcefully, which
may break the pushing tip. It is very
easy to remove the pin by pushing out from the front. However, to install the
pin which is to push from the back of the pin it is a little difficult. The
orbital need to be arranged tightly to the nosebridge. If the frame is not well
arranged, the pushing tip will create a lot of stress to the pushing tip and
the frame. It will result in either damage to the frame or/and the pushing tip.
PLEASE TAKE CAUTION DURING OPERATION. WE DO NOT ACCETP ANY RESPONSIBILITY FOR ANY DAMAGE FROM HUMAN ERROR TO THE PUSHING TIP AND/OR THE FRAME.
Please check any defect
before use, we accept un-used item return. In that case, please contact us
immediately. In most case, no restocking fee for return item is applied. If you
are not confident, a professional tuning up service is recommended. Please use
it your own risk since the value of Oakley X-Metal is quite high.
Attached components
Pin Pusher Body
Pushing Tip(1) for Removing Pin
Pushing Tip(2) for Installing Pin
Base 1 (Attached)
Compatibility : Can use for following Models.
JULIET, X-METAL XX, PENNY, MARS, ROMEO2
This listing is NOT including Nose Bridge Flex Coupler and Nose Bridge Pin. (Sell separately)