Application:
This is screen
printer with vacuum pallet, suitable for all kinds of high
precision and exquisite plane screen printing, especially
for light and thin materials like paper, plastic sheet, CD,
credit card, PCB, and all kinds of film, card, board and
paper.
Also suitable for all kinds of transfer paper, PVC, PET, PC
and other soft/ hard film, board, paper, nameplate, and
similar materials.
It can also be used for the fine printing on heavy and thick
products, such as paper boxes, glass, wood boards, metal
plates, signage, various plastic boards and etc.
Not
suitable for cloth, ribbons, handkerchiefs and other textile
products, textile materials are recommended to use the
scraping pallet with glue.
Character:
1,
The printing object can be tightly adsorbed on the pallet,
to prevent the printing object moved by outside force.
2. After printing,
vacuum pallet can keep the printing object close to the
pallet can won't be lift up by ink.
3. Equip
with 3 gravity balance plates, they can be installed
individually or together according to weight request, it can
be moved forward and back within 4 inches (10cm ).
With the bolt in the balance rack,
could adjust the lifting angle and height of the screen
frame.
Function:
This screen printing table uses 2 mm stainless steel plate
laser cutting, table area is 40x50 cm; Vacuum area is
42x31.5 cm; Suction hole diameter is 1 mm; The spacing of
air holes is 15 mm. The quantity of air holes are 638 (22
rows in horizontal direction and 29 rows in vertical
direction).
Three-directions micro adjustable, it can be micro adjusted
through the knob up and down , forward and back 3/4 inch,
left and right 3/4 inch ;
Place the substrate on the table surface and start the
vacuum pump. Clamp the screen frame after aligning the
screen pattern with the substrate.
Height adjustment: place
the screen frame flat on the platform. According to the
substrate height or printing requirements, rotate the up and
down adjustment handle to reach the appropriate height, and
lock the height through the two rear positioning handles.
Left and right
adjustment: loosen the handle on both
sides of the nose, and rotate the handle to move slightly
left and right as required; When it is done, tighten both
handles.
Back and forward
adjustment: first, slightly loosen the
four red knobs on the front of the chuck, then loosen the
fine-tuning knobs on both sides of the front of the chuck
and make front and rear fine-tuning as required. After the
fine-tuning, tighten the knob and tighten the four red knobs
on the top of the chuck.
When substrate area is too small, adsorption will reduce,
you can cover the blowholes around the substrate with
plastic sheets or paper to increase the adsorption of
substrate.
|