You get a sealed bag of 100 Basic Terminators with 75 Ohm Resistor

The terminators are made by PPC and are model # TR75S 

Poor electrical terminations caused by cheap terminators can wreak havoc on system performance. 
Common faulty 75 Ohm terminations caused by poor performance result in service calls. 
PPC provides industry leading return loss and shielding performance, improving network uptime and reducing service calls.

Also known as Dummy Loads, terminators are an essential component in the proper termination of unused outputs of line splitters and amplifiers which utilize a Type F interface. 

  • 75 Ohm termination caps on F type connections help to optimize system performance.
  • It is essential to use coax terminators on empty unused ports as it makes a significant difference.
  • A coaxial connector left without a terminator is just like going a water tap running off. 
  • Terminators are simple devices that electrically terminate RF coaxial ports, both inside and outside of the home.
  • The unused tap ports or wall plates in the home can actually create a path for ingress and egress, which affects the network performance.
  • Every splitter port is essential, and one needs to use it or cap it using a terminator.
  • The available port’s signal strength will reduce when you do not use the extra lines, and every new line available adds loss to the entire setup, this, most times, does affect the signal quality.
  • These F-81 Terminator caps are for use on any unused splitter ports, amplifier ports, or unused cable TV outlets. 
  • These F-81 Terminator caps close cable system connections, preventing ghosting and other TV signal problems.
  • They work to keep strong signals from reflecting back and producing problems with TV picture quality or causing interference with nearby radio communications.

Technical Data 

Electrical Specifications

Return Loss
5 to 1,000 MHz -30 dB Minimum
1,000 to 2000 MHz -30 dB Minimum
2,000 to 3,000 MHz -20 dB Minimum

Shielding Effectiveness -120 dB Minimum
Corrosion Resistance: meets SCTE and Belcore per ATSM B 117 (1000 hour salt fog)
Moisture Migration: Meets SCTE IPS·TP-013 when used with WSS00 weather seal (Red-dye moisture migration test)
Meets or Exceeds all SCTE Specifications

PPC Part Number: TR75S 
Description: 75Ω Basic Terminator