Description:

A polyester resin, 2‐part, rapid curing, chemical anchoring system. Applied in one single action to produce a cost effective, tough chemical resistant fixing.

Uses

Suitable for setting bolts, studs, wall ties, starter bars or large screws, etc into a wide range of substrates. Compatible with brickwork, concrete, masonry, stone and PFA blocks. Hollow base materials can also be securely fastened using ANCHOR BOND in

conjunction with a sleeve or sieve.

Chemically resistant, waterproof and vibration proof.

Preparation

Drill a hole to the correct diameter and depth (see chart over leaf), ideally using a rotary percussion machine. For optimum results the wall sides should be thoroughly roughened. Clean holeand remove all dust and debris using a hand air pump or a stiff rotary brush, if required.

All bars should be clean and free from oil or grease and all flaking rust should be removed. Threaded rods or studs should be chisel

ended to prevent them being unscrewed from the cured resin.

Application

Screw the mixing nozzle on to the cartridge (hand tighten). Place the ANCHOR BOND cartridge into the dispensing gun. Squeeze the hand trigger a few times until material passes through the mixing nozzle. Allow the material to flow until an even colour is obtained (normally 5-6 inches). Insert the nozzle into the base of the hole and extrude material, half filling the hole with resin. 

Withdraw the nozzle then insert the fixing into the filled hole, slowly rotating to fully coat the surface. After application release the pressure from the dispensing gun. Remove the used mixing nozzle and wipe away excess material from the end of the cartridge. Once the resin has cured the fixture can be attached to the fixing and fully tightened. Do not over pressurise cartridge otherwise leakage may occur from rear pistons.

Curing

Dependant on temperature. As a guide @ 20oC:-

Gel Time: 5 minutes.

Full Cure: 2 hours.

Container Size

Available in 310ml and 400ml plastic cartridges with special mixing

nozzle.

Colour

Grey in colour.

Shelf Life

12 months from date of manufacture when stored in unopened

cartridges.

Storage Conditions

Store in a dry area between 5oC and 25oC. Keep out of direct

sunlight. Storage at higher temperatures will reduce the shelf life.

Disposal of Containers

Do not leave empty containers where residue could be harmful to

children, animals or the environment. Replace lids and remove

any containers to a central disposal point in accordance with local

regulations.

Health & Safety

Contains styrene.

Please refer to separate material safety data sheet for full

handling, use and storage instructions. Keep out of reach of

children. It is the users responsibility to determine suitability for

use. If in doubt contact our Technical Department for advice.

Note: this information is for general guidance only, since site conditions

and labour are beyond our control. It is recommended that users make

their own tests to determine suitability.

Product Details:

Code: BDAB310

Size: 310ml

Barcoode: 5060021368669

Package Content

310ml Anchor Bond Adhesive Chemical Studding Polyester Resin Mortar Anchoring UK