Specifications:
Item condition - New
Brand - GATE-RC
Frequency - 433.92MHz.
Operating voltage - 12V DC-24V DC AC
Codes：Fixed / Learning / Rolling Code
Transmit distance - 50-100m in open space. Open space means no any interference. No walls, no doors, no trees or any other obstructions. Interference like garage door or brick wall can reduce remote control range significantly.
1 receiver can store 200pcs of rolling code remote control
433MHz Rolling code receiver
1) Can learn Fixed and Rolling code 433,92Mhz remote controls separately and simultaneously !!!
2) Can learn and use most Original 433,92Mhz Fixed and Rolling code remote controls !!! ( Such as : BFT, V2 , Ditec，CAME, MOOVO, MHOUSE PUJOL, GIBIDI, DOORHAN, ATA PTX4, MARANTEC )
3) 2 channel receiver provides you with an option to control and use 2 gate automations or alarm systems simultaneously
4) 1 relay can store 200 pcs remote control, the receiver can store 400 pcs remote control
Remote control transmitter
Decoder IC - rolling code.
Frequency - 433.92MHz.
Operating voltage - 12V DC 23A (Free battery included)
High safety factor chip, scrolling code, unable to be copied
Ultra long transmission distance, To be used with our receiver, can reach a distance of 50-100 meters
INSTALLATION:
Position the receiver in a place adequately protected from atmospheric agents 1) Connect the wires coming from the power supply to the VDD+ and GND- terminals 2) Connect the wires coming from the device to the NO and CM terminals of the chosen channel
wide range of uses:
Garage doors, Electronic gates, Barrier gates, sliding doors, automatic doors, rolling doors, shutters
Electrical appliances/Home automation i.e. lights, Alarm system, access control system
Easy to use:
Relay 1 Momentary Mode programming
Press once P1 button (the learning key P1 on the receiver board), The LED lights up for 1 second, then goes out and lights up again. At this point, press any key on the remote control, the learning code light will flash, and the learning code will be successful. Then release the remote control button
Relay 2 Momentary Mode programming
Pressing 2 times P1 button (the learning key P1 on the receiver board), The LED flashing 2 times. At this point, press any key on the remote control, the learning code light will flash, and the learning code will be successful. Then release the remote control button
Relay 1 self-locking Mode programmin
Pressing 3 times P1 button (the learning key P1 on the receiver board), The LED flashing 3 times. At this point, press any key on the remote control, the learning code light will flash, and the learning code will be successful. Then release the remote control button
Relay 2 self-locking Mode programmin
Pressing 4 times P1 button (the learning key P1 on the receiver board), The LED flashing 4 times. At this point, press any key on the remote control, the learning code light will flash, and the learning code will be successful. Then release the remote control button