Feature:
1. PORTABLE: For SHARI (for SR FRS1W Ham Allstar Radio Interface) is compact and portable with separate radio and antenna, designed for amateur radio service construction and use with for Pi2 Pi3 Pi4. for SHARI output power is 500 to 1000 (default) milliwatts.
2. EMBEDDED MODULE: For SHARI (for SA818 Ham Allstar Radio Interface) is a ham build project designed by for N8AR that implements a for RPi hosted for Allstar node using the for NiceRF SA818 embedded UHF (420‑450 MHz) radio module.
3. WIDE APPLICATION: To create the for Allstar node, for SHARI plugs into two USB jacks on the for RPi 2 Pi3 Pi4 for power, for Allstar interface and radio programming (a short M F USB extender cable can be used if needed); note: only for the for Allstar node or any analog node.
4. USAGE: For SHARI is designed to be built and used in the Amateur Radio Service by licensed Amateur Radio operators who can ensure that their assembled for SHARI kits meet the operational requirements set by the FCC, including frequencies, deviations, and required power levels at fundamental and harmonic frequencies.
5. FEATURES: For Ham Allstar Radio Interface for Pi2 Pi3 Pi4 (USB connector location swap), use for Cmedia CM119B or for CM108B USB sound ICs, use for NiceRF SA818 UHF or VHF embedded radio modules, change radio settings using the program running on for RPi.
Specification:
Item Type: Radio Interface Module
Material: Metal
UHF Frequency Range: 420‑450 MHz
Compatible: for RPi2 for RPi3 for RPi4
Feature:
Works with a for RPi2 for RPi3 or for RPi4 (USB connector positions swapped)
Uses the for Cmedia CM119B or for CM108B USB sound IC
Uses a for NiceRF SA818 UHF or VHF embedded radio module
500 to 1000(default) milliwatts output power
Small, portable with self contained radio and antenna
Radio settings changed using a program running on the for RPi
Required Hardware:
1. A fully assembled for SHARI Pi3U Pi3V Pi4U Pi4V.
2. A for RPi 2 for RPi 3 or for RPi 4 . The for RPi2 or for RPi3 is normally used with the for SHARI Pi3(U) ,while the for RPi4 is normally used with the for SHARI Pi4(U)
3. A case for the for RPi. A metal case is preferred but if you want to use a WiFi connection instead of a wired network connection then a plastic case may be required to obtain adequate range.
4. A micro storage card , 16GB or larger, Class 10 or better is recommended.
5. A power supply for the for RPi. This should be a power supply intended for the version of the for RPi. These supplies typically provide 5.1 to 5.2 VDC to the for Pi. Current requirements vary with version. Numerous problems with for Allstar Nodes have been traced to inadequate power supplies.
for SHARI Allstar Node Setup and Configuration Guide (In short version)
1. Create an Account with for Allstar
2. Create a Server and Request a Node number
3. Software
4. Configuring for Allstar
5. Configuring Simple USB Tune Menu for SHARI
6. Connecting and Configuring for SHARI
7. Setting Receive and Transmit Voice Levels
8. Testing DTMF Decoding
9. Enabling the LED
Package List:
1 x Radio Module
1 x Antenna
