NOTE: SPECIAL $465.00 ON THIS BRAND NEW ODYSSEY TRIPLE TRACK 10 SHORT SLANT NECK WITH THE New UNCUT, UPGRADED $495.00 BGT STABILITY SPECIAL EDITION MASTER'S TOUR PEARL WHITE PUTTER SHAFT SHOWN IN THE LISTING PICTURES, INSTALLED & BUILT TO YOUR SPECS WITH A NEW STOCK ODYSSEY PUTTER GRIP, this low price special is with the Special Edition Masters Pearl White M version shaft, if the buyer wants any of the  other Tour Stability shafts in the Ghost Black or Tour Fire Red or Cobalt Blue they are 485.00 or for the low Special on the Tour Polar White the price is 385.00 under a different listing, which is a really great deal, as this shaft was listed at 330.00  by itself. I have several of the Polar White shafts & got them on a good deal so passing the savings on to my buyers, they are NOT DEMO shafts but new uncut authentic Polar White Stability shafts

Note: I will install the trademark to where it doesn't show at address, just at the position shown for pictures only unless the buyer lets me know at time of purchase.

NOTE: THESE SHAFTS THAT I SELL AND INSTALL ARE NEW UNCUT SHAFTS AND NOT THE DEMO VERSIONS SEEN ON EBAY AND BEING PASSED OFF AS NEW OVER RUN SHAFTS, THEY ARE DEMO ONLY SHAFTS, MADE FOR  DEMO ONLY APPLICATIONS AND AREN'T EVEN TO BE SOLD, UNLESS FOR DEMO APPLICATIONS, AS THE DEMO STICKER STATES, THESE DEMO SHAFTS HAVE VARIOUS ISSUES DURING FABRICATION THAT BGT REMOVED DURING INSPECTION AND HAD THEM REMOVED FROM THEIR PRODUCTION SHAFTS AND HAVE LABELED THEM AS SUCH.

NOTE: I JUST RECENTLY FOUND A TOOL, THAT ALLOWS ME TO MEASURE PUTTER SHAFTS TORQUE, THIS IS THE AMOUNT THE SHAFT WILL TWIST AT IMPACT & ALSO CAUSES THE SHAFT TO OPEN UP & ALSO ADD LOFT,  SO HERE IS WHAT I FOUND OUT, THE BGT STABILITY SHAFTS INDEED HAVE ONLY 1 DEGREE OF TORQUE, AS STATED,  NEXT IS THE AFTERMARKET KBS ONE PIECE TAPERED STEEL SHAFTS THAT HAVE 2.8 DEGREES, THIS ALSO INCLUDES THE OTHER HEAVY ONE-PIECE TAPERED STEEL SHAFTS, ALTHOUGH I DID HAVE A NEW APOLLO ONE PIECE TAPERED SHAFT THAT WAS A LITTLE BIT HIGHER AT 3.0 DEGREES, THE NEW T/M FLUTED FEEL PUTTER SHAFTS HAVE 3.8 DEGREES, THE KBS & SEVERAL OTHER STEPPED STEEL PUTTER SHAFTS, LIKE THE OLDER TM SPIDER SHAFTS WERE 3.2-3.4 DEGREES & THE ODYSSEY STROKE LAB PUTTER SHAFTS HAD THE HIGHEST TORQUE AT 3.9-4.0 DEGREES DEPENDING ON THE LENGTH OF THE STEEL TIP, THESE SHAFTS HAVE A SMALL GRAPHITE PIECE INSERTED INTO THE GRAPHITE UPPER SECTION & EPOXIED TO THE STEEL TIP, I SUSPECT THIS METHOD OF COMBINING THE UPPER SECTION TO THE LOWER STEEL TIP SECTION, CAUSES A LOT OF THIS HIGH TORQUE.

     

NOTE: UP FOR SALE ON BUY-IT-NOW FOR 465.00. BRAND NEW STILL HAS PLASTIC ON THE HEAD, AN ODYSSEY TRIPLE TRACK 10, #3 SHORT SLANT NECK PUTTER AT 35 INCHES PLUS & COMES WITH A NEW UNCUT  BGT STABILITY SPECIAL EDITION MASTER'S TOUR  PEARL WHITE PUTTER SHAFT, as shown in the listing for the special price of $525.00 or if the buyer wants one of the other colors the price would be 485.00 for the TOUR GHOST BLACK or TOUR FIRE RED,  or TOUR COBALT BLUE COMPOSITE PUTTER SHAFT, THIS SHAFT LISTS FOR 330.00 DOLLARS THRU BGT WITHOUT INSTALLATION & SHIPPING, IT IS A RIGHT HANDED, ONE OF THE NEWER ODYSSEY PUTTERS THAT IS SLIGHT TOE DOWN, THAT IS PREFERRED BY MANY TOUR PLAYERS, BECAUSE THEY CAN PUTT BOTH WAYS WITH THEM & IT WEIGHS 364 GRAMS RIGHT NOW, WITH I ASSUME, TWO 15 GRAM WEIGHTS IN THE SOLE FROM THE FACTORY, BUT I ALSO HAVE HEAVIER WEIGHTS AVAILABLE FOR AN UPGRADE FEE IF THE BUYER CHOOSES,  WITH AN UPGRADED, AFTERMARKET STABILITY PUTTER SHAFT THAT LISTS NOW IN 2023 FOR 330.00 DOLLARS, WITHOUT A GRIP, SHIPPING OR INSTALLATION OR FOR THE CARBON STABILITY SHAFT THAT LISTS FOR 210.00, WITHOUT A GRIP OR INSTALLATION, SO IF THE BUYER WANTS THE STABILITY CARBON SHAFT THE PRICE WOULD BE $350, GRIP CHOICES WOULD BE SEVERAL STOCK ODYSSEY GRIPS BUYERS CHOICE, WHICH I AM INCLUDING IN THE LISTING PRICE, OR FOR AN UPGRADE FEE I ALSO HAVE MANY OTHER AFTERMARKET PUTTER GRIPS ALSO.

    I AM AN AUTHORIZED DEALER FOR THESE GREAT SHAFTS, & HAVE ALREADY SOLD MANY OF THESE SHAFTS ON ALL MAKES OF PUTTERS, SO HAVE COMBINED EITHER OF THESE GREAT SHAFTS TO THIS GREAT PUTTER, THE CARBON IS UNDER A SEPARATE LISTING, FOR 350.00, I ALSO REMOVED THE STROKE LAB SHAFT WHICH ARE VERY SOFT & ALWAYS HAVE FROM 30-40 GRAMS A BRASS WEIGHT IN THE BUTT OF THE STROKE LAB SHAFT, THIS COUNTER BALANCES THE TOTAL LENGTH OF THE PUTTER, WHICH KEEPS FROM ALLOWING THE PLAYER TO BE ABLE TO FEEL THE HEAD DURING THE STROKE, THE LIGHT SHAFT, WILL OPEN UP ADDING LOFT & CAUSES DISPERSION ISSUES, SO BY CHANGING THE SHAFT TO  EITHER STABILITY SHAFT,  THE Tour 2 or the Carbon over the Stroke Lab shaft, IT MAKE THIS PUTTER INCREDIBLY MUCH BETTER. I TOOK THE PICTURES OF THE TOUR GHOST BLACK SHAFT, WHICH REALLY GOES GOOD WITH THE TRIPLE TRACK ALIGNMENT GUIDE, INSTALLED IN IT WITH A BLACK STEEL TIP SECTION, BUT CHROME OR SILVER TIPS I ALSO HAVE INSTEAD, JUST LET ME KNOW AT TIME OF PURCHASE, BUT I WILL INSTALL EITHER THE TOUR GHOST BLACK or TOUR FIRE RED or THE TOUR 2 POLAR WHITE.  IF THE BUYER WOULD RATHER HAVE THE CARBON STABILITY INSTEAD, LET ME KNOW. THESE BGT STABILITY SHAFTS HAVE ONLY 1 DEGREE OF TORQUE RATHER THAN STEEL PUTTER SHAFTS THAT START AT 2.8 DEGREES SUCH AS THE ONE PIECE STEEL PUTTER SHAFTS, THE STEPPED STEEL SHAFTS ARE HIGHER &  THE STOCK STROKE LAB SHAFT IS EVEN HIGHER YET, ODYSSEY ALSO AREN'T CONSISTENT IN THEIR TIP LENGTHS EITHER SOME ARE LONGER AT 8-9 INCHES PROTRUDING & SOME  SHORTER, THEN THEY USE A SMALL PIECE OF GRAPHITE AT .3125 (5/16) DIAMETER TO COUPLE THE STEEL TIP TO THE UPPER GRAPHITE SECTION.  THEN AS MENTIONED ABOVE, THEY INSTALL A 30-40 GRAM BRASS WEIGHT IN THE BUTT SECTION TO COUNTERBALANCE THE UPPER SHAFT. FROM EXPERIENCE MOST PLAYERS PUTT MUCH BETTER BY REMOVING THIS BRASS WEIGHT FROM UNDER THE GRIP & PUTT EXTREMELY BETTER WITH THE BGT STABILITY SHAFT INSTALLED INSTEAD OF THE STROKE LAB, WHICH IS A CHEAP IMITATION OF THE TRUE BGT STABILITY COMPOSITE PUTTER SHAFT. THE STOCK PUTTER GRIP IS HEAVY ALSO, WEIGHING 80 PLUS GRAMS & OVER THIS MAKES FEELING THE PUTTER HEAD DURING THE STROKE HARD TO ADJUST TO.  MOST PLAYERS I  HAVE WORKED WITH DO MUCH BETTER GETTING THE 30- 40 GRAM BUTT WEIGHT OUT OF THE BUTT OF THE STROKE LAB SHAFT & GETTING THE PUTTER HEAD HEAVIER BY ADDING HEAVIER WEIGHTS SO THEY CAN FEEL THE HEAD BETTER. THESE STROKE LAB SHAFTS AGAIN HAVE AN EVEN MUCH HIGHER TORQUE RATING, WHICH CAUSES DISPERSION, ADDING LOFT & TWISTING DURING IMPACT. THE STABILITY SHAFT IS MADE OF CARBON FIBER & HIGH MODULUS TORAY GRAPHITE IN THE UPPER SECTION COUPLED TO A STEEL LOWER 5 1/2 INCH, SECTION WITH NO TAPER, WHICH IS STIFFER, THIS GIVES THE PLAYER MUCH BETTER DISPERSION & DISTANCE CONTROL OVER THE SOFTER WHPPIER STROKE LAB SHAFTS.  THE BGT STABILITY SHAFTS ARE MORE STABLE, STRONGER WITH MUCH LESS TORQUE, STILL HAVE GREAT FEEL & ARE BEING USED BY MANY TOUR PRO'S, NOW ON TOUR.

   IF THE BUYER WANTS ONE OF THE SUPER STROKE WEIGHTED, COUNTER BALANCED GRIP INSTALLED, ADD 45.00 WHICH INCLUDES ONLY ONE WEIGHT.  EITHER THE 25 G, 50 G OR 75 G WEIGHT, EACH OTHER ONE ADDED IS 15.00 EACH EXTRA, AND I ALSO HAVE CUSTOM MADE ONES THAT ARE LIGHTER THAN 25 GRAMS, 10, 15 & 20 Grams OR IN BETWEEN 25-50 GRAMS, I MADE ONE AT 38 GRAMS FOR MY CLUB PRO HERE IN MONTANA, AS THE 25 G WAS TO LIGHT & THE 50 G TO HEAVY, so the 38 Gram I made him was perfect OR THERE ARE ALSO MANY OTHER AFTERMARKET GRIPS AVAILABLE, ALSO, THAT I HAVE IN STOCK, MENTIONED ABOVE, FROM SUPER STROKE, WINN, GOLF PRIDE, IOMIC & ETC., SEVERAL ARE INCLUDED IN THE PICTURES. WHEN CHANGING GRIPS, GOING FROM A SMALL STOCK GRIP TO A LARGER GRIP, THE LARGER GRIP WILL WEIGH MORE, THE HEAVIER GRIP WILL CHANGE THE SWING WEIGHT ON THE PUTTER, STANDARD LENGTH PUTTER HEADS WEIGH FROM 350-370 GRAMS,  THIS ONE WEIGHS 364 GRAMS. BUT IT IS VERY IMPORTANT TO HAVE THE CORRECT PUTTER LENGTH TO GET YOUR EYES OVER THE BALL & ON THE LINE YOU PICK WHEN STANDING BEHIND THE BALL, TO LONG OF A PUTTER WILL CAUSE THE TOE TO BE UP & NOT FLAT OR YOUR EYES WILL BE WAY INSIDE THE INTENDED TARGET LINE. THE LONGER THE SHAFT THE HEAVIER THE SWING WEIGHT WILL BE, SO ALL OF THESE VARIABLES MAKE HAVING AN ADJUSTABLE WEIGHTED PUTTER A REAL POSITIVE, TO ALLOW THE PLAYER TO BE ABLE TO ADJUST, TO FURTHER IMPROVE THEIR PUTTER

    I will shorten or lengthen the putter length to whatever length the buyer needs at no cost or install many of the other different grips that I have in stock also, for an upgrade charge, depending on which grip is wanted by the buyer.  I am a professional club fitter & install the grip exactly 90 degrees square to the face so the flat spot on the grip is aligned perfectly square with the face at address, most grip installers just eyeball this procedure & it is hit and miss, making it not square to the face, as I have corrected many that were not done correctly, making them slightly open or closed, this keeps the player from rolling the putt true on their intended line. The weight system in the grip allows the player to quiet the hands during the stroke, or to make the putter into a counter balanced unit by adding different weights to help control the players stroke. If you have a putter that you would like upgraded to a Stability Composite putter shaft or something else, please get in touch with me & we can discuss your options further, I also have built many ARM -LOCK & the new Lean Lock putters for my customers locally here in Montana in the summer & Phoenix in the winter, & throughout the country, so if you ARE INTERESTED IN ANY OF THESE LONGER PUTTERS, & WANT TO USE THIS HEAD AS A FOUNDATION, I DO HAVE EXTRA WEIGHTS TO GET THE HEAD OVER 400 grams, LET ME KNOW AND I WILL GIVE YOU A QUOTE to make this putter into an ARM LOCK, Counter Balanced, Lean Lock, Side Saddle or interested in what I have, such as several different face balanced putters & even a center shafted one as well, so please let me know & we can discuss your options. I also have these putters for sale locally so may end the