SPECIFICATION:

Battery Life: ≥5 years

Operating Temperature: -40°C – 125°C

Storage Temperature: -40°C t – 125°C

Operating Humidity: ≤90%

Operating Frequency: 315 MHz~433MHz

Max. Pressure range: 800 kPa

Temperature Reading Range: -40°C – 125°C

Temperature Reading Accuracy: ±5°C

G Sensor Reading Accuracy: ±15%

Transmission Power: 5-8dBm

Battery: 3.0 V

Dimensions: Approx. 42.4*24.1*16.0 mm

Weight of Sensor without Valve: 11 g

【Installation Process for Rubber Stem (Screw-In)】

1. Loosening the tire: Remove the valve cap and core and deflate the tire. Use the bead loosener to unseat the tire bead.

2. Dismounting the tire: Clamp the tire onto the tire changer, and adjust the valve at 1 o’clock relative to the tire separation Insert thetire tool and lift the tire bead onto the mounting head to dismount the bead.

3. Dismountingthe sensor: Depress the Pressbutton on the sensor body. Carefully pull the sensor body straight back off the valve. Cut the rubber bulb and attach a standard tire valve extractor to the valve. Remove the valve from the rim by pulling through the rim.

4. Mounting sensor and valve:

· Connect the sensor body and valve stem at a suitable angle (normallyuse the maximum angle of 30 degrees) and tighten the screw. Apply tire soap or lube solution to the rubber valve stem.

· Line the sensor up with the rim hole and attach a standard tire valve extractor to the end of the valve.

· Pull the valve stemstraight through the valve hole. Note the rubber bulb of the valve resting against the rim.

5. Mounting the tire: Place the tire on the rim, make sure that the valve faces the separationhead at an angle of 180 degrees. Mount the tire over the rim.